M27C1024-20B7X Ver la hoja de datos (PDF) - STMicroelectronics
Número de pieza
componentes Descripción
Fabricante
M27C1024-20B7X Datasheet PDF : 16 Pages
| |||
M27C1024
Table 5. AC Measurement Conditions
Input Rise and Fall Times
Input Pulse Voltages
Input and Output Timing Ref. Voltages
High Speed
≤ 10ns
0 to 3V
1.5V
Standard
≤ 20ns
0.4V to 2.4V
0.8V and 2V
Figure 5. AC Testing Input Output Waveform
High Speed
3V
0V
Standard
2.4V
0.4V
1.5V
2.0V
0.8V
AI01822
Figure 6. AC Testing Load Circuit
1.3V
1N914
DEVICE
UNDER
TEST
3.3kΩ
CL
OUT
CL = 30pF for High Speed
CL = 100pF for Standard
CL includes JIG capacitance
AI01823B
Table 6. Capacitance (1) (TA = 25 °C, f = 1 MHz)
Symbol
Parameter
CIN
Input Capacitance
COUT Output Capacitance
Note: 1. Sampled only, not 100% tested.
Test Condition
VIN = 0V
VOUT = 0V
Min
Max
Unit
6
pF
12
pF
DEVICE OPERATION
The modes of operations of the M27C1024 are
listed in the Operating Modes table. A single pow-
er supply is required in the read mode. All inputs
are TTL levels except for VPP and 12V on A9 for
Electronic Signature.
Read Mode
The M27C1024 has two control functions, both of
which must be logically active in order to obtain
data at the outputs. Chip Enable (E) is the power
control and should be used for device selection.
Output Enable (G) is the output control and should
be used to gate data to the output pins, indepen-
dent of device selection. Assuming that the ad-
dresses are stable, the address access time
(tAVQV) is equal to the delay from E to output
(tELQV). Data is available at the output after a delay
of tOE from the falling edge of G, assuming that E
has been low and the addresses have been stable
for at least tAVQV-tGLQV.
Standby Mode
The M27C1024 has a standby mode which reduc-
es the active current from 35mA to 100µA.
The M27C1024 is placed in the standby mode by
applying a TTL high signal to the E input. When in
the standby mode, the outputs are in a high imped-
ance state, independent of the G input.
4/16
Share Link: 