AT89C1051 Ver la hoja de datos (PDF) - Atmel Corporation

Número de pieza

componentes Descripción

Fabricante

AT89C1051

8-Bit Microcontroller with 1K Byte Flash

Atmel Corporation 

AT89C1051

Chip Erase: The entire PEROM array (1K byte) and the

two Lock Bits are erased electrically by using the proper

combination of control signals and by holding P3.2 low for

10 ms. The code array is written with all “1”s in the Chip

Erase operation and must be executed before any non-

blank memory byte can be re-programmed.

Reading the Signature Bytes: The signature bytes are

read by the same procedure as a normal verification of

locations 000H, 001H, and 002H, except that P3.5 and

P3.7 must be pulled to a logic low. The values returned are

as follows.

(000H) = 1EH indicates manufactured by Atmel

(001H) = 11H indicates 89C1051

Programming Interface

Every code byte in the Flash array can be written and the

entire array can be erased by using the appropriate combi-

nation of control signals. The write operation cycle is self-

timed and once initiated, will automatically time itself to

completion.

Figure 3. Programming the Flash Memory

RDY/BSY

PROG

SEE FLASH

PROGRAMMING

MODES TABLE

AT89C1051

P3.1

VCC

P3.2

P1

P3.3

P3.4

P3.5

P3.7

5V

PGM

DATA

Figure 4. Verifying the Flash Memory

VI H

SEE FLASH

PROGRAMMING

MODES TABLE

AT89C1051

VCC

P3.2

P1

P3.3

P3.4

P3.5

P3.7

5V

PGM

DATA

TO INCREMENT

ADDRESS COUNTER

XTAL1

GND

RST

VI H/ VPP

XTAL1

RST

VI H

GND

4-9

Share Link: