AS3588AQ Ver la hoja de datos (PDF) - austriamicrosystems AG

Número de pieza

componentes Descripción

Fabricante

AS3588AQ

DIGITAL TIME/SPACE CROSSPOINT SWITCH

austriamicrosystems AG 

Data Sheet

AS3588A

26 - 27 23 - 26 IP A1, S1, A2, S2 Address Decoder Inputs

These active high inputs are provided for larger non blocking digital

switching matrixes with cascaded AS 3588 devices.

30

27

IP

C/D

Control/ Data Select Input

The signal on this control input defines whether the data on the data

bus should be interpreted as opcode or as data. During a write

operation a low signal defines the bus content as data and a high

signal defines it as opcode. During a read operation this input acts as

multiplexing control: OR1 is selected by a low signal; OR2 is selected

by a high signal.

31

28 Power

VSS

Negative Supply Voltage

32

29

IP

RESET

Reset Input

This active low input is used for starting the system initialization. This

pin is strobed at the first timeslot. The initialization routine takes one

time frame period independent of the reset pulse width and is

continued for another time frame when the signal is kept low during

strobe. Initialization disables the output drivers of the microprocessor

interface; The Connection Memory is cleared and the PCM output

drivers are disabled.

33 - 34 30 - 31 IP

CS1, CS2

Chip Select Inputs

These are the inputs for the active low chip selects on the

microprocessor interface. The two inputs are provided for flexible

decoding.

35

32

IP

WR

Write Input

This active low input is for the write signal on the microprocessor

interface. The data bus is strobed on the rising edge.

36

34

IP

RD

Read Input

This active low input is for the read signal on the microprocessor

interface. The databus is updated on the falling edge.

37 - 40 35 - 38 OP

OUTPCM 7 to PCM Outputs 7 to 4

OUTPCM 4 These are open drain outputs for four primary rate PCM output

streams.

Functional Description

The AS3588A is a digital time / space crosspoint

switching matrix and is designed to switch data from

eight primary rate input ports operating at 2048 kbit/s

to eight primary rate 2048 kbit/s output ports.

Simultaneously it allows its controlling microprocessor

to read PCM output channels or write to PCM output

channels (Messaging). To the Microprocessor

AS3588A looks like a memory mapped peripheral de-

vice that is controlled by six different instructions. It

can write to AS3588A commands to establish or

release switched connections between PCM input

channels and PCM output channels or to transmit

messages on specific PCM output channels. By

reading from the AS3588 the microprocessor can

receive messages from PCM output channels or from

the channel 0 of the input ports or check which

connections have been made by reading the

connection memory.

By integrating both switching and interprocessor

communications the AS3588A is ideally suited for dis-

tributed processing in digital switching systems.

Hardware Description

Timing

All AS3588 internal timing is derived from the 4.096

MHz master clock signal CK and the 8 kHz frame syn-

chronization signal SYNC. Different time bases for the

serial to parallel PCM input converter and the parallel

to serial PCM output converter are generated internally

which compensate for the internal input/output

conversion delays. They are synchronized to a preset

number in order to restore the channel and bit se-

Rev. 3.1

Page 3 of 15

July 1999

Share Link: