RS-422 Ver la hoja de datos (PDF) - Unspecified

Número de pieza

componentes Descripción

Fabricante

RS-422

RS-422 AND RS-485 APPLICATION NOTE

Unspecified 

Chapter 1: Overview

Introduction

The purpose of this application note is to describe the main elements of

an RS-422 and RS-485 system. This application note attempts to cover

enough technical details so that the system designer will have considered all

the important aspects in his data system design. Since both RS-422 and RS-

485 are data transmission systems that use balanced differential signals, it is

appropriate to discuss both systems in the same application note. Throughout

this application note the generic terms of RS-422 and RS-485 will be used to

represent the EIA/TIA-422 and EIA/TIA-485 Standards.

Data Transmission Signals

Unbalanced Line Drivers

Each signal that transmits in an RS-232 unbalanced data transmission

system appears on the interface connector as a voltage with reference to a

signal ground. For example, the transmitted data (TD) from a DTE device

appears on pin 2 with respect to pin 7 (signal ground) on a DB-25 connector.

This voltage will be negative if the line is idle and alternate between that

negative level and a positive level when data is sent with a magnitude of ±5 to

±15 volts. The RS-232 receiver typically operates within the voltage range of

+3 to +12 and -3 to

-12 volts as shown in Figure 1.1.

Balanced Line Drivers

In a balanced differential system the voltage produced by the driver

appears across a pair of signal lines that transmit only one signal. Figure 1.2

shows a schematic symbol for a balanced line driver and the voltages that

exist. A balanced line driver will produce a voltage from 2 to 6 volts across

its A and B output terminals and will have a signal ground (C) connection.

Although proper connection to the signal ground is important, it isn't used by

a balanced line receiver in determining the logic state of the data line. A

balanced line driver can also have an input signal called an “Enable” signal.

The purpose of this signal is to connect the driver to its output terminals, A

and B. If the “Enable” signal is OFF, one can consider the driver as

disconnected from the transmission line. An RS-485 driver must have the

“Enable” control signal. An RS-422 driver may have this signal, but it is not

always required. The disconnected or "disabled" condition of the line driver

usually is referred to as the “tristate1” condition of the driver.

1 The term “tristate” comes from the fact that there is a third output state of an

RS-485 driver, in addition to the output states of “1” and “0.”

RS-422/485 Application Note

1

B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350

PH (815) 433-5100 -- FAX (815) 434-7094

Share Link: