MU9C4480A Ver la hoja de datos (PDF) - MUSIC Semiconductors

Número de pieza

componentes Descripción

Fabricante

MU9C4480A

LANCAM A/L series (not recommended for new designs)

MUSIC Semiconductors 

Pin Descriptions

LANCAM A/L series (not recommended for new designs)

PIN DESCRIPTIONS

Note: All signals are implemented in CMOS technology with TTL levels. Signal names that start with a slash (“/”) are active LOW.

Inputs should never be left floating. The CAM architecture draws large currents during compare operations, mandating the use of good

layout and bypassing techniques. Refer to the DC Electrical Characteristics on page 26 for more information.

/E (Chip Enable, Input, TTL)

The /E input enables the device while LOW. The falling

edge registers the control signals /W, /CM, and /EC. The

rising edge locks the daisy chain, turns off the DQ pins,

and clocks the Destination and Source Segment counters.

The four cycle types enabled by /E are shown in Table 1.

Table 1: I/O Cycles

/W

LOW

LOW

HIGH

HIGH

/CM

LOW

HIGH

LOW

HIGH

Cycle Type

Command Write Cycle

Data Write Cycle

Command Read Cycle

Data Read Cycle

/W (Write Enable, Input, TTL)

The /W input selects the direction of data flow during a

device cycle. /W LOW selects a Write cycle and /W HIGH

selects a Read cycle.

/CM (Data/Command Select, Input, TTL)

The /CM input selects whether the input signals on

DQ15–0 are data or commands. /CM LOW selects

Command cycles and /CM HIGH selects Data cycles.

/EC (Enable Daisy Chain, Input, TTL)

The /EC signal performs two functions. The /EC input

enables the /MF output to show the results of a

comparison, as shown in Figure 8 on page 14. If /EC is

LOW at the falling edge of /E in a given cycle, the /MF

output is enabled. Otherwise, the /MF output is held

HIGH.

The /EC signal also enables the /MF–/MI daisy chain,

which serves to select the device with the highest-priority

match in a string of LANCAMs. Table 4 explains the

effect of the /EC signal on a device with or without a

match in both Standard and Enhanced modes. /EC must be

HIGH during initialization.

DQ15–0 (Data Bus, I/O, TTL)

The DQ15–0 lines convey data, commands, and status to

and from the LANCAM. /W and /CM control the direction

and nature of the information that flows to or from the

device. When /E is HIGH, DQ15–0 go to HIGH-Z.

/MF (Match Flag, Output, TTL)

The /MF output goes LOW when one or more valid

matches occur during a compare cycle. /MF becomes valid

after /E goes HIGH on the cycle that enables the daisy

chain (on the first cycle that /EC is registered LOW by the

previous falling edge of /E; see Figure 8 on page 14). In a

daisy chain, valid match(es) in higher priority devices are

passed from the /MI input to /MF. If the daisy chain is

enabled but the match flag is disabled in the Control

register, the /MF output only depends on the /MI input of

the device (/MF=/MI). /MF is HIGH if there is no match

or when the daisy chain is disabled (/E goes HIGH when

/EC was HIGH on the previous falling edge of /E). The

System Match flag is the /MF pin of the last device in the

daisy chain. /MF is reset when the active configuration

register set is changed.

Rev. 1

Figure 2: PLCC Pinout

3

Share Link: