MAX9923F(2009) Ver la hoja de datos (PDF) - Maxim Integrated

Número de pieza

componentes Descripción

Fabricante

MAX9923F
(Rev.:2009)

Ultra-Precision, High-Side Current-Sense Amplifiers

Maxim Integrated 

Ultra-Precision, High-Side

Current-Sense Amplifiers

ELECTRICAL CHARACTERISTICS (continued)

(VRSB = VRS+ = VRS- = +12V, VDD = +3.3V, VGND = 0, VREF = VDD/2 for bidirectional, VREF = 0 for unidirectional, VSENSE = VRS+ - VRS- = 0,

MAX9922 is set for AV =100V/V (R1 = 1kΩ, R2 = 99kΩ), SHDN = VDD, TA = -40°C to +85°C, unless otherwise noted. Typical values are at

TA = +25°C.) (Note 1)

PARAMETER

SYMBOL

CONDITIONS

MIN TYP MAX UNITS

Power-Down Supply Current

IRSBL VDD = VREF = 0, VRSB = VRS+ = VRS- = 28V

0.05

1

µA

Power-Up Time

MAX9922, AV = 100V/V, VREF = 0, VSENSE =

10mV, VDD = 0 to 3.3V, settling to 0.1% of final

800

µs

value

Note 1:

Note 2:

Note 3:

Note 4:

Note 5:

Note 6:

Note 7:

All devices are 100% production tested at TA = +85°C. All temperature limits are guaranteed by design.

VOS is measured in bidirectional mode with VREF = VDD/2.

Data sheet limits are guaranteed by design and bench characterization. Thermocouple effects preclude measurement of

this parameter during production testing. Devices are screened during production testing to eliminate defective units.

VOS drift limits are guaranteed by design and bench characterization and are the average of drift from -40°C to +25°C and

from +25°C to +85°C.

VRSB = VRS+ = 12V, VREF = VDD/2 for bipolar mode and VREF = 0 for unipolar mode. Gain accuracy and gain linearity are

specified over a VSENSE range that keeps the output voltage 250mV away from the rails to achieve full accuracy. Output of

the part is rail-to-rail, and goes to within 25mV of the rails, but accuracy is not maintained. Linear operation is not guaran-

teed for VSENSE voltages > ±150mV. See the Typical Operating Characteristics section for plots of Input vs. Output.

This is the worst-case REF current needed to directly drive the bottom terminal of the gain setting resistors, at VDD = 3.3V,

and VREF = VDD/2. An internal 1kΩ resistor (R1) is present in the MAX9923T/MAX9923H/MAX9923F between the FB and

REF pins, while in the MAX9922 the resistor is external and user selectable. A voltage identical to the VSENSE develops

across this resistor. In all versions the REF input current is dependent on the magnitude and polarity of VSENSE, and in the

MAX9922 it is dependent on the value of the external resistor as well. See the External Reference section for more details.

The range of VREF, VCM, and VSENSE may limit the output swing of the MAX9922 with adjustable gain set to less than

100V/V.

_______________________________________________________________________________________ 5

Share Link: