MAX9011 Ver la hoja de datos (PDF) - Maxim Integrated

Número de pieza

componentes Descripción

Fabricante

MAX9011

SC70, 5ns, Low-Power, Single-Supply, Precision TTL Comparators

Maxim Integrated 

SC70, 5ns, Low-Power, Single-Supply,

Precision TTL Comparators

Note 4: Although Common-Mode Input Voltage Range is restricted to -0.2V ≤ VCM ≤ (VCC - 1.9V), either or both inputs can go to either

absolute maximum voltage limit, i.e., from -0.3V to (VCC + 0.3V), without damage. The comparator will make a correct (and fast)

logic decision provided that at least one of the two inputs is within the specified common-mode range. If both inputs are outside

the common-mode range, the comparator output state is indeterminate.

Note 5: For the MAX9012, Input Offset Voltage is defined as the input voltage(s) required to make the OUT output voltage(s) remain

stable at 1.4V. For the MAX9013, it is defined as the average of two input offset voltages, measured by forcing first the OUT

output, then the OUT output to 1.4V.

Note 6: Propagation delay for these high-speed comparators is guaranteed by design because it cannot be accurately measured

with low levels of input overdrive voltage using automatic test equipment in production. Note that for low overdrive

conditions, VOS is added to the overdrive.

Note 7: Differential Propagation Delay, measured either on a single output of the MAX9012/MAX9013 (or between OUT and OUT

outputs on the MAX9013) is defined as: ∆tPD(±) = |(tPD+) - (tPD-)|.

Note 8: Latch times are guaranteed by design. Latch setup time (tSU) is the interval in which the input signal must be stable prior to

asserting the latch signal. The hold time (tH) is the interval after the latch is asserted in which the input signal must remain

stable. Latch propagation delay (tLPD) is the delay time for the output to respond when the latch enable pin is deasserted

(see Figure 1).

(VCC = 5V, CL = 15pF, TA = +25°C, unless otherwise noted.)

Typical Operating Characteristics

0

IN

-100mV

3V

RESPONSE TO +5mV OVERDRIVE

MAX9010–13 toc01

+100mV

IN

0

3V

RESPONSE TO -5mV OVERDRIVE

MAX9010–13 toc02

OUT

0

IN: 50mV/div

OUT: 1V/div

t = 5ns/div

OUT

0

IN: 50mV/div

OUT: 1V/div

t = 5ns/div

PROPAGATION DELAY

vs. INPUT OVERDRIVE

6.0

5.5

tPD(+)

5.0

4.5

tPD(-)

4.0

3.5

3.0

1

10

100

OVERDRIVE (mV)

_______________________________________________________________________________________ 5

Share Link: