MAX7375AXR425-T Ver la hoja de datos (PDF) - Maxim Integrated

Número de pieza

componentes Descripción

Fabricante

MAX7375AXR425-T

3-Pin Silicon Oscillator

Maxim Integrated 

3-Pin Silicon Oscillator

Applications Information

Interfacing to a Microcontroller Clock

Input

The MAX7375 clock output is a push-pull, CMOS, logic

output, which directly drives any microprocessor (µP)

or microcontroller (µC) clock input. There are no imped-

ance-matching issues when using the MAX7375.

Operate the MAX7375 and microcontroller (or other

clock input device) from the same supply voltage level.

Refer to the microcontroller data sheet for clock input

compatibility with external clock signals.

The MAX7375 requires no biasing components or load

capacitance. When using the MAX7375 to retrofit a

crystal oscillator, remove all biasing components from

the oscillator input.

Startup Performance

The MAX7375 oscillator output stabilizes within a few

cycles of operation after V+ rises to a sufficient voltage

to start the oscillator, typically 1.65V at +25°C. Use a

reset or similar voltage-detection circuit to disable

devices connected to the MAX7375 until 5µs after the

voltage on V+ has risen above 2.7V.

Extended Temperature Operation

The MAX7375 was tested to +135°C during product

characterization and shown to function normally at this

temperature (see Typical Operating Characteristics).

However production test and qualification is only per-

formed from -40°C to +125°C at this time. Contact the

factory if operation outside this range is required.

Power-Supply Considerations

The MAX7375 operates with power-supply voltages in

the 2.7V to 5.5V range. Good power-supply decoupling

is needed to maintain the power-supply rejection per-

formance of the MAX7375. Use a 0.1µF surface-mount

ceramic capacitor connected between V+ and GND

and mounted as close to the device as possible. If pos-

sible, mount the MAX7375 close to the microcontroller’s

decoupling capacitor so that additional decoupling is

not required.

A larger value of bypass capacitor is recommended if

the MAX7375 is to operate with a large capacitive load.

Use a bypass capacitor value of at least 1000 times

that of the output load capacitance.

PART

MAX7375AXR105

MAX7375AXR185

MAX7375AXR365

MAX7375AXR375

MAX7375AXR405

MAX7375AXR425

MAX7375AXR805

MAX7375AUR105

MAX7375AUR185

MAX7375AUR365

MAX7375AUR375

MAX7375AUR405

MAX7375AUR425

MAX7375AUR805

Selector Guide

FREQUENCY (MHz)

1.00

1.84

3.58

3.69

4.00

4.19

8.00

1.00

1.84

3.58

3.69

4.00

4.19

8.00

TOP MARK

AOV

AOU

AOT

AOS

AOR

AOQ

AOP

FZPZ

FZPT

FZPU

FZPV

FZPY

FZPW

FZPX

Pin Configuration

TOP VIEW

V+ 1

CLOCK 1

MAX7375AXR 3 GND

CLOCK 2

MAX7375AUR 3 GND

V+ 2

SC70

SOT23

Chip Information

TRANSISTOR COUNT: 432

PROCESS: BiCMOS

_______________________________________________________________________________________ 5

Share Link: