MAX7033(2004) Ver la hoja de datos (PDF) - Maxim Integrated
Número de pieza
componentes Descripción
Fabricante
MAX7033 Datasheet PDF : 16 Pages
| |||
315MHz/433MHz ASK Superheterodyne
Receiver with AGC Lock
AC ELECTRICAL CHARACTERISTICS (continued)
(Typical Application Circuit, AVDD = DVDD = VDD5 = +3.0V to +3.6V, all RF inputs are referenced to 50Ω, fRF = 315MHz, TA = -40°C
to +105°C, unless otherwise noted. Typical values are at AVDD = DVDD = VDD5 = +3.3V and TA = +25°C.) (Note 1)
PARAMETER
SYMBOL
CONDITIONS
MIN TYP MAX UNITS
Maximum Load Capacitance
Output High Voltage
Output Low Voltage
CLOAD
10
pF
VDD5
V
0
V
CRYSTAL OSCILLATOR
Crystal Frequency (Note 5)
Crystal Tolerance
fXTAL
fRF = 433MHz
fRF = 315MHz
VXTALSEL = 0V
VXTALSEL = VDD5
VXTALSEL = 0V
VXTALSEL = VDD5
6.6128
13.2256
4.7547
9.5094
50
MHz
ppm
Input Capacitance
From each pin to ground
6.2
pF
Note 1: 100% tested at TA = +25°C. Guaranteed by design and characterization over temperature.
Note 2: IRSEL is internally set to 375MHz IR mode. It can be left open when the 375MHz image-rejection setting is desired. Bypass
to AGND with a 1nF capacitor in a noisy environment.
Note 3: BER = 2 x 10-3, Manchester encoded, data rate = 4kbps, IF bandwidth = 280kHz.
Note 4: Input impedance is measured at the LNAIN pin. Note that the impedance includes the 15nH inductive degeneration con-
nected from the LNA source to ground. The equivalent input circuit is 50Ω in series with 2.2pF.
Note 5: Crystal oscillator frequency for other RF carrier frequency within the 300MHz to 450MHz range is (fRF - 10.7MHz) / 64 for
XTALSEL = 0V, and (fRF - 10.7MHz) / 32 for XTALSEL = VDD5.
Typical Operating Characteristics
(Typical Application Circuit , AVDD = DVDD = VDD5 = +3.3V, fRF = 315MHz, TA = +25°C, unless otherwise noted.)
SUPPLY CURRENT
vs. SUPPLY VOLTAGE
6.0
5.8
5.6
+105°C
5.4
+85°C
5.2
5.0
4.8
4.6
+25°C
4.4
4.2
-40°C
4.0
3.0 3.1 3.2 3.3 3.4 3.5 3.6
SUPPLY VOLTAGE (V)
7.0
6.5
6.0
5.5
5.0
4.5
4.0
3.5
3.0
250
SUPPLY CURRENT
vs. RF FREQUENCY
+105°C
+85°C
+25°C
-40°C
300 350 400 450 500
RF FREQUENCY (MHz)
BIT-ERROR RATE
vs. PEAK RF INPUT POWER
100
fRF = 433MHz
10
1
fRF = 315MHz
0.1
0.01
-130 -128 -126 -124 -122 -120 -118 -116 -114
PEAK RF INPUT POWER (dBm)
_______________________________________________________________________________________ 5
Share Link: 