MAX1230 Ver la hoja de datos (PDF) - Maxim Integrated
Número de pieza
componentes Descripción
Fabricante
MAX1230 Datasheet PDF : 23 Pages
| |||
12-Bit 300ksps ADCs with FIFO,
Temp Sensor, Internal Reference
ABSOLUTE MAXIMUM RATINGS
VDD to GND ..............................................................-0.3V to +6V
CS, SCLK, DIN, EOC, DOUT to GND.........-0.3V to (VDD + 0.3V)
AIN0–AIN13, REF-/AIN_, CNVST/AIN_,
REF+ to GND.........................................-0.3V to (VDD + 0.3V)
Maximum Current into Any Pin............................................50mA
Continuous Power Dissipation (TA = +70°C)
16-Pin QSOP (derate 8.3mW/°C above +70°C)...........667mW
20-Pin QSOP (derate 9.1mW/°C above +70°C)...........727mW
24-Pin QSOP (derate 9.5mW/°C above +70°C)...........762mW
28-Pin Thin QFN 5mm x 5mm
(derate 20.8mW/°C above +70°C) ........................1667mW
Operating Temperature Ranges
MAX12__C__.......................................................0°C to +70°C
MAX12__E__ ....................................................-40°C to +85°C
Storage Temperature Range .............................-60°C to +150°C
Junction Temperature ......................................................+150°C
Lead Temperature (soldering, 10s) .................................+300°C
Soldering Temperature (reflow) .......................................+260°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
ELECTRICAL CHARACTERISTICS
(VDD = +5V ±5%, fSAMPLE = 300kHz, fSCLK = 4.8MHz (50% duty cycle), VREF = 4.096V, TA = TMIN to TMAX, unless otherwise noted.
Typical values are at TA = +25°C.)
PARAMETER
SYMBOL
CONDITIONS
MIN
DC ACCURACY (Note 1)
Resolution
Integral Nonlinearity
Differential Nonlinearity
RES
12
INL
DNL No missing codes over temperature
Offset Error
Gain Error
(Note 2)
Offset Error Temperature
Coefficient
Gain Temperature Coefficient
Channel-to-Channel Offset
Matching
DYNAMIC SPECIFICATIONS (30kHz sine wave input, 4.096VP-P, 300ksps, fSCLK = 4.8MHz)
Signal-to-Noise Plus Distortion
SINAD
Total Harmonic Distortion
Spurious-Free Dynamic Range
THD
SFDR
Up to the 5th harmonic
Intermodulation Distortion
Full-Power Bandwidth
IMD fin1 = 29.9kHz, fin2 = 30.2kHz
-3dB point
Full-Linear Bandwidth
S / (N + D) > 68dB
TYP
±0.5
±0.5
±2
±0.8
±0.1
73
-88
89
76
1
100
MAX UNITS
±1.0
±1.0
±4.0
±4.0
Bits
LSB
LSB
LSB
LSB
ppm/°C
FSR
ppm/°C
LSB
dB
dBc
dBc
dBc
MHz
kHz
2 _______________________________________________________________________________________
Share Link: 