050-043-7701229 Ver la hoja de datos (PDF) - ITT Cannon

Número de pieza

componentes Descripción

Fabricante

050-043-7701229

RF Coaxial Connectors

ITT Cannon  

RF Coaxial Connectors

Assembly Instructions

AI-90, AI-237, AI-773 & BBAI-1212 SMA & MCX Right Angle Connectors, Crimp Type for Braided Cable

HEAT SHRINKABLE

TUBING

CRIMP

FERRULE

CAP

BODY ASSEMBLY

1. Slide ferrule and (if supplied) heat shrinkable tubing on to cable.

2. Trim cable to dimensions shown.

Assembly Instruction No.

AI-90 & AI-237

AI-773

BBAI-1212

A

11,10 (.437)

11,68 (.460)

8,50 (.335)

B

5,16 (.203)

4,55 (.179)

3,00 (.118)

3. Tin center conductor (DO NOT OVER TIN).

C

1,57 (.062)

1,78 (.070)

2,00 (.078)

4. Slide body over cable dielectric and under the braid until braid is flush against under-side of body.

Ensure center conductor is located in the forked end of the contact.

NOTE: When using cables with inflexible jackets it is permissible to make two 3,17 (.125)

longitudinal slits in the outer jacket.

5. Slide ferrule flush against the body and crimp in position using ITT Cannon’s Crimp Tool and

suitable die set (see table).

6. Using a small soldering iron solder center conductor to contact.

NOTE: The center conductor should not protrude beyond the contact or touch the body. Solder

should not protrude beyond the slotted section of the contact.

7. Locate the cap in rear of body and dimple or lightly punch to ensure it is locked in position.

8. Slide heat shrinkable tubing over ferrule flush against body and heat until tubing shrinks down.

Only common cable retention features are shown in detail. Various body configurations can apply.

Cable

RG142/U

RG196/U

RG316/U

RD 316

Cable Code

9142

9196

9188

9399/9875

Die Size

5,42 (.213)

2,67 (.105)

3,25 (.128)

3,84 (.151)

Dimensions are shown in mm (inch)

110

Dimensions subject to change

Share Link: