AS1702-T Ver la hoja de datos (PDF) - austriamicrosystems AG
Número de pieza
componentes Descripción
Fabricante
AS1702-T Datasheet PDF : 20 Pages
| |||
AS1702 - AS1705
Data Sheet - Detailed Description
8 Detailed Description
The AS1702 - AS1705 are 1.8W high output-current audio amplifiers (configured as BTL amplifiers), and contain inte-
grated low-power shutdown and click- and pop-suppression circuitry. Two inputs (SHDM and SHDN) allow shutdown
mode to be configured as active-high or active-low (see Shutdown Mode on page 11).
Each device has either adjustable or fixed gains (0dB, 3dB, 6dB) (see Ordering Information on page 19).
Bias
The devices operate from a single 2.7 to 5.5V supply and contain an internally generated, common-mode bias voltage
of:
VCC
(EQ 1)
2
referenced to ground. Bias provides click-and-pop suppression and sets the DC bias level for the audio outputs. Select
the value of the bias bypass capacitor as described in Section BIAS Capacitor on page 15.
Note: Do not connect external loads to BIAS as this can adversely affect overall device performance.
Shutdown Mode
All devices implement a 100nA, low-power shutdown circuit which reduces quiescent current consumption. As shut-
down mode commences, the bias circuitry is automatically disabled, the device outputs go high impedance, and bias is
driven to GND.
The SHDM input controls the polarity of SHDN:
! Drive SHDM high for an active-low SHDN input.
! Drive SHDM low for an active-high SHDN input.
Table 6. Shutdown Mode Selection Configurations
SHDM
SHDN
Mode
0
0
Shutdown Mode Enabled
0
1
Normal Operation Enabled
1
0
Normal Operation Enabled
1
1
Shutdown Mode Enabled
Click-and-Pop Suppression
During power-up, the device common-mode bias voltage (VBIAS (see page 4)) ramps to the DC bias point. When enter-
ing shutdown, the device outputs are driven high impedance to 100kΩ between both outputs minimizing the energy
present in the audio band, thus preventing clicks and pops.
www.austriamicrosystems.com
Revision 1.47
11 - 20
Share Link: 