24C64 Ver la hoja de datos (PDF) - STMicroelectronics

Número de pieza

componentes Descripción

Fabricante

24C64

64-Kbit serial I²C bus EEPROM

STMicroelectronics 

Signal description

2

Signal description

M24C64-W M24C64-R M24C64-F

2.1

Serial Clock (SCL)

The signal applied on the SCL input is used to strobe the data available on SDA(in) and to

output the data on SDA(out).

2.2

Serial Data (SDA)

SDA is an input/output used to transfer data in or data out of the device. SDA(out) is an

open drain output that may be wire-OR’ed with other open drain or open collector signals on

the bus. A pull-up resistor must be connected from Serial Data (SDA) to VCC (Figure 14

indicates how to calculate the value of the pull-up resistor).

2.3

Chip Enable (E2, E1, E0)

(E2,E1,E0) input signals are used to set the value that is to be looked for on the three least

significant bits (b3, b2, b1) of the 7-bit device select code (see Table 2). These inputs must

be tied to VCC or VSS, as shown in Figure 6. When not connected (left floating), these inputs

are read as low (0). For the 5-balls WLCSP package (see Figure 3), the (E2,E1,E0) inputs

are internally connected to (0,0,1).

Figure 6. Chip enable inputs connection

9&&

9&&

0[[[

(L

966

0[[[

(L

966

$L

2.4

Write Control (WC)

This input signal is useful for protecting the entire contents of the memory from inadvertent

write operations. Write operations are disabled to the entire memory array when Write

Control (WC) is driven high. Write operations are enabled when Write Control (WC) is either

driven low or left floating.

When Write Control (WC) is driven high, device select and address bytes are

acknowledged, Data bytes are not acknowledged.

8/45

DocID16891 Rev 30

Share Link: