6EP1332-1SH52 Ver la hoja de datos (PDF) - Siemens AG

Número de pieza

componentes Descripción

Fabricante

6EP1332-1SH52

Power supply LOGO!Power

Siemens AG 

Description, device design, dimension drawing

1.2 Connections and terminal designation

1.2

Connections and terminal designation

The line input terminals ① can be used to establish the connection to supply voltage. The

output terminals ② to be supplied are used to connect the loads (see also Section

Installation (Page 17)).

Connections and terminal designations

① Supply input L1, N

② Output +

② Output –

One screw terminal each for 0.5 to 2.5 mm²

2 screw terminals for 0.5 mm to 2.5 mm²

2 screw terminals for 0.5 mm to 2.5 mm²

Figure 1-2 Terminal data

1.3

Potentiometer

The potentiometer ③ on the front of the device is used to set the output voltage. The output

voltage is set to the rated value at the factory and can be set within certain limits; for

example, to compensate voltage drops across long supply lines to the connected load.

Type

5V

12 V

15 V

24 V

Factory setting

5V

12 V

15 V

24 V

Setting range

4.6 to 5.4 V

10.5 to 12.9 V

13.9 to 16.1 V

22.2 to 26.4 V

WARNING

Actuation of the potentiometer is allowed only be means of an insulated screwdriver.

Notes on potentiometer operation (such as a screwdriver, torque) refer to Chapter

Connections and terminal designation (Page 10), Fig. Terminal data.

LOGO!Power

10

Operating Instructions, 02.2011, C98130-A7560-A999-1-7619

Share Link: