SPT9691 Ver la hoja de datos (PDF) - Signal Processing Technologies
Número de pieza
componentes Descripción
Fabricante
SPT9691 Datasheet PDF : 10 Pages
| |||
ELECTRICAL SPECIFICATIONS
T A = +25 °C, AVCC = +10 V, AVEE=-10.0 V, DVEE=-5.2 V, RL = 50 Ohm to -2V, unless otherwise specified.
PARAMETERS
TEST
CONDITIONS
TEST
LEVEL
MIN
TYP
DC ELECTRICAL CHARACTERISTICS
Power Dissipation
Dual
I
700
Output High Level
ECL 50 Ohms to -2V
I
-.98
Output Low Level
ECL 50 Ohms to -2V
I
-1.95
AC ELECTRICAL CHARACTERISTICS
Propagation Delay1
150 mV O.D.
IV
1.5
2.0
Propagation Delay TEMPCO
V
2
Propagation Delay Skew (A vs B)
V
100
Propagation Delay Dispersion2
150 mV Overdrive Min.
V
200
Latch Set-up Time
V
1.7
Latch to Output Delay
150 mV O.D.
V
0.8
Latch Pulse Width
V
2
Latch Hold Time
V
-1.9
Rise Time
20% to 80%
V
0.4
Fall Time
20% to 80%
V
0.4
Slew Rate
V
3
MAX
895
-.70
-1.65
2.5
NOTES:
1 Valid for both high-to-low and low-to-high transitions.
2 Dispersion is the change in propagation delay due to changes in slew rate, overdrive, and common mode level.
UNITS
mW
V
V
ns
ps/ °C
ps
ps
ns
ns
ns
ns
ns
ns
V/ns
TEST LEVEL CODES
TEST LEVEL
All electrical characteristics are subject to the
I
following conditions:
II
All parameters having min/max specifications
are guaranteed. The Test Level column indi-
III
cates the specific device testing actually per-
IV
formed during production and Quality Assur-
ance inspection. Any blank section in the data
V
column indicates that the specification is not
tested at the specified condition.
VI
TEST PROCEDURE
100% production tested at the specified temperature.
100% production tested at TA=25 °C, and sample
tested at the specified temperatures.
QA sample tested only at the specified temperatures.
Parameter is guaranteed (but not tested) by design
and characterization data.
Parameter is a typical value for information purposes
only.
100% production tested at TA = 25 °C. Parameter is
guaranteed over specified temperature range.
SPT
3
SPT9691
10/6/97
Share Link: 