SA9401 Ver la hoja de datos (PDF) - South African Micro Electronic Systems

Número de pieza

componentes Descripción

Fabricante

SA9401

UNIVERSAL PABX TONE GENERATOR

South African Micro Electronic Systems 

SA9401

PCM Interface

The PCM Interface controls all aspects of the transfer of PCM signals onto the PCM

highway.

Eight-bit Tone Registers store the PCM tone samples and are updated once per PCM

frame. Before a PCM word is transmitted to the PCM highway the Tone Selector

determines whether or not the Cadence controller requires an OFF period. If so then a

specific PCM word for Silence (held in the Silence Register) is substituted for the tone

sample.

The actual transfer of the tone (or silence) samples to the PCM highway is the function

of the Injection Controller. Time Slot Registers indicate to which PCM time-slot the

sample is to be injected. These registers (one for each tone stream) comprise 5 ad-

dress bits and one (high-order) enabling bit. A Comparator checks if the Time Slot

Register contents match the current PCM time-slot and if so feeds the Tone Sample (or

Silence Sample) into the Parallel In Serial Out module and the required sample is

clocked out via the PCM_OUT pin. The PCM_OUT pin is enabled only when samples

are being clocked out (ie when the 5 least significant bits of the Time Slot Register

matches the current PCM Time Slot and the Time Slot Register MSB is Low) and is

held in a tri-state condition at all other times.

Watchdog Timer

The watchdog timer performs a function completely independently of the Universal Tone

Generator. Its operation is described below.

The watchdog timer comprises three I/O pins, viz;

WD_EN - an active low input which enables/disables the watchdog.

WD_RST - a rising edge triggered input which resets the watchdog timer and

prevents the output from resetting the microprocessor.

WD_INT - an active low tri-state output which when active, resets a micro-

processor.

The watchdog timer operates as follows:

- For the watchdog timer to operate, the WD_EN pin must be held low (i.e. active).

With the WD_EN pin held high, the WD_INT output remains tri-stated.

The delay between WD_EN going active and a WD_INT output is 2 seconds.

- The timer is reset every time a rising edge is detected on the WD_RST pin. The

minimum pulse width of the WD_RST input is two CLKIN periods.

- The WD_INT output comprises an active low pulse of 5 milliseconds followed by a

tri-state period of 1995 milliseconds (assuming no valid WD_RST pulse is detected

within 2 seconds of the previous WD_RST pulse).

The timing diagram for the Watchdog Timer is given in Figure 2. Note that although the

timebase for the Watchdog Timer is always 2048kHz, the WD-EN and WD-RST inputs

are strobed at the external clock rate.

sames

7

Share Link: