UPC4091G2 Ver la hoja de datos (PDF) - NEC => Renesas Technology

Número de pieza

componentes Descripción

Fabricante

UPC4091G2

J-FET INPUT LOW-OFFSET OPERATIONAL AMPLIFIER

NEC => Renesas Technology 

µPC4091

ABSOLUTE MAXIMUM RATINGS (TA = 25 °C)

Parameter

Symbol

Ratings

Unit

Voltage between V+ and V–Note 1

V+ – V–

–0.3 to +36

V

Differential Input Voltage

VID

Input VoltageNote 2

VI

Output VoltageNote 3

VO

Power Dissipation

C PackageNote 4

PT

G2 PackageNote 5

Output Short Circuit DurationNote 6

±30

V

V––0.3 to V+ +0.3

V

V––0.3 to V+ +0.3

V

350

mW

440

mW

Indefinite

sec

Operating Ambient Temperature

TA

–20 to +80

°C

Storage Temperature

Tstg

–55 to +125

°C

Notes 1. Reverse connection of supply voltage can cause destruction.

2. The input voltage should be allowed to input without damage or destruction. Even during the transition

period of supply voltage, power on/off etc., this specification should be kept. The normal operation will

establish when the both inputs are within the Common Mode Input Voltage Range of electrical

characteristics.

3. This specification is the voltage which should be allowed to supply to the output terminal from external

without damage or destructive. Even during the transition period of supply voltage, power on/off etc., this

specification should be kept. The output voltage of normal operation will be the Output Voltage Swing of

electrical characteristics.

4. Thermal derating factor is –5.0 mV/°C when operating ambient temperature is higher than 55 °C.

5. Thermal derating factor is –4.4 mV/°C when operating ambient temperature is higher than 25 °C.

6. Pay careful attention to the total power dissipation not to exceed the absolute maximum ratings, Note 4

and Note 5.

RECOMMENDED OPERATING CONDITIONS

Parameter

Supply Voltage

Output Current

Capacitive Load (AV = +1, Rf = 0 Ω)

Symbol

MIN.

TYP.

MAX.

Unit

V±

±5

±16

V

IO

±10

mA

CL

10000

pF

OFFSET VOLTAGE NULL CIRCUIT

2–

6

+

5

3

1

10 kΩ

VR1

V–

Remark The OFFSET NULL pins should be left

open or connected to V– via a resistor

as shown in the left figure. Don't

connect to any lines other than V–,

otherwise mulfunction, degradation, or

failure may occur.

2

Share Link: