L9947 Ver la hoja de datos (PDF) - STMicroelectronics

Número de pieza

componentes Descripción

Fabricante

L9947

QUAD HALF-BRIDGE AND SINGLE HIGH-SIDE DRIVER

STMicroelectronics 

Figure 2: System Startup Sequence

L9947

OObbssoolleettee

PPrroodduucctt((ss))

-

-

OObbssoolleettee

PPrroodduucctt((ss))

SYSTEM STARTUP (figure 2)

It is not mandatory that VS is present before VCC.

With the presence of the VCC the internal logic

would be reseted and the system restarts under

control of the inputs. If CSN = 0 for more than

100µs after the presence of VCC the standby

mode is activated. Standby is also activated when

the CSN and VCC would be high at the same

time. When CSN = 0 and VCC goes up, the device

is not controlled by the bus. The outputs remain in

tristate but the current consumption is larger than

100µA. A high - low - signal at the CSN - wire is

mandatory to control the outputs. There is no un-

dervoltage detection level for the supply voltage

VS implemented. The VCC should be supplied

from the same voltage supply as the driver of the

D0 -D3 pins (eg. µC).

7/13

Share Link: