MF606G Ver la hoja de datos (PDF) - YCL Electronics

Número de pieza

componentes Descripción

Fabricante

MF606G

Asymmetric Digital Subscriber Line

YCL Electronics  

Product Specification

MF606G

4.3. ZHP-r Definition:

To facilitate the test of the splitter , the high pass data have to be taken into consideration.

ZHP-r shown below is defined to allow proper termination of the ADSL port during voice

band testing, and ZHP-r is valid only for voice band frequency. ZHP-r is almost the same as

27nF + 470µ H // 100Ω defined inAS/ACIF.

4.4. DC characteristic:

All requirement of this specification can be met in the presence of all POTS loop currents

from 0mA to 120mA. This in line filter can pass POTS tip-to-ring dc voltages of 0V to 72V

and ringing signals of 40V to 80Vrms at any frequency from15.3Hz to 68Hz with a dc

component in the range from 0V to 72V. The dc resistance from tip-to-ring at the line port

interface with the phone interface shorted, shall be less than or equal to 100 ohms for one

filter. The DC resistance from tip-to-ground and from ring-to-ground at the POTS

interface with the U-R interface open shall be greater than or equal to 5 Megohms. The

ground point shall be local building or green wire ground. As an objective , the dc resistance

should exceed 10MΩ.

Data sheet subject to change without notice

RDPS-MF063(R1)01/15/2003

SHEET 7 OF 11

Share Link: