T8110 Ver la hoja de datos (PDF) - Agere -> LSI Corporation

Número de pieza

componentes Descripción

Fabricante

T8110

Ambassador® T8110 PCI-Based H.100/H.110 Switch and Packet Payload Engine

Agere -> LSI Corporation 

Advisory

September 2001

Ambassador ® T8110

Version History

Introduction

The purpose of this advisory is to provide information on the different versions of the Ambassador T8110.

T8110 Version 1

Models of the T8110 V1 had two device issues. The two device issues only affect the microprocessor interface

and packet switching capabilities. The T8110 V1 can function as a 4096 connection standard telephony switch

when using the PCI interface.

Issue 1:

Microprocessor interface: The RDY(DTACKn) signal can oscillate if the microprocessor device

driving the microprocessor interface does not relinquish its RDn (or WRn) signal within one

65 MHz clock cycle after the reassertion of RDY (Intel® mode) or deassertion of DTACKn

(Motorola® mode).

Workaround: The processor or board-level component driving the microprocessor port must deassert RDn

or WRn immediately (within 15 ns) upon reassertion of RDY.

Issue 2:

Packet switch malfunction: The T8110 does not disable its upper byte lanes on the descriptor

table update, resulting in an over-write of descriptor table data. The descriptor table update

occurs as the last phase of a PCI Master PUSH & PULL cycle. This results in virtual channel

connection malfunctions. TDM switching is unaffected.

Workaround: A systemic workaround for the user is to keep a shadow table for the UOR portion of the

descriptor table.

T8110 version 1 models can be identified by the markings on the device or by reading the version ID register. If

the last line of the device markings is a 7 digit number followed by no version number, then the device is a ver-

sion 1. Reading the version ID register 0x00128 will read back a value of 01h, indicating the device is version

1.

Samples of version 1 are no longer available (version 2 samples are now available).

T8110 Version 2

Models of the T8110 V2 have one device issue. The device issue only affects the packet switching capabilities.

The T8110 V2 can function as a 4096 connection standard telephony switch when using either PCI or micro-

processor interface.

Issue 1 (from version 1): Fixed. The microprocessor interface issue has been resolved.

Issue 2 (from version 1): Will be fixed in version 3.

T8110 version 2 models can be identified by the markings on the device or by reading the version ID register. If

the last line of the device markings is a 7 digit number followed by V2, then the device is a version 2. Reading

the version ID register 0x00128 will read back a value of 02h, indicating the device is a version 2.

Samples of version 2 are currently available.

For additional information, contact your local FAE (field application engineer), or call 1-800-372-2447.

Share Link: