ADP3333ARM-1.5 Ver la hoja de datos (PDF) - Analog Devices

Número de pieza

componentes Descripción

Fabricante

ADP3333ARM-1.5

High Accuracy Ultralow IQ, 300 mA, anyCAP® Low Dropout Regulator

Analog Devices 

ADP3333

Calculating Junction Temperature

Device power dissipation is calculated as follows:

( ) ( ) PD = VIN − VOUT ILOAD + VIN IGND

Where ILOAD and IGND are load current and ground current, VIN

and VOUT are the input and output voltages respectively.

Assuming the worst-case operating conditions are ILOAD =

300 mA, IGND = 2.6 mA, VIN = 4.0 V and VOUT = 3.0 V, the

device power dissipation is:

PD = (4.0 V − 3.0 V ) 300 mA + (4.2 V ) 2.0 mA = 308 mW

The package used on the ADP3333 has a thermal resistance of

158°C/W for 4-layer boards. The junction temperature rise

above ambient will be approximately equal to:

TJA = 0.308 W × 158°C / W = 48.7°C

So, to limit the junction temperature to 125°C, the maximum

allowable ambient temperature is:

TA(MAX ) = 125°C − 48.7°C = 76.3°C

Shutdown Mode

Applying a high signal to the shutdown pin, or connecting it to

the input pin, will turn the output ON. Pulling the shutdown

pin to 0.3 V or below, or connecting it to ground, will turn the

output OFF. In shutdown mode, the quiescent current is reduced

to less than 1 µA.

Printed Circuit Board Layout Considerations

Use the following general guidelines when designing printed

circuit boards:

1. Keep the output capacitor as close to the output and ground

pins as possible.

2. Keep the input capacitor as close to the input and ground

pins as possible.

3. PC board traces with larger cross sectional areas will remove

more heat from the ADP3333. For optimum heat transfer,

specify thick copper and use wide traces.

4. Connect the NC pins (Pins 5, 6, and 8) to ground for better

thermal performance.

5. The thermal resistance can be decreased by approximately

10% by adding a few square centimeters of copper area to

the lands connected to the pins of the LDO.

6. Use additional copper layers or planes to reduce the thermal

resistance. Again, connecting the other layers to the ground and

NC pins of the ADP3333 is best, but not necessary. When

connecting the ground pad to other layers use multiple vias.

REV. 0

–7–

Share Link: