1EDI2004AS Ver la hoja de datos (PDF) - Infineon Technologies

Número de pieza

componentes Descripción

Fabricante

1EDI2004AS

High Voltage IGBT Driver for Automotive Applications

Infineon Technologies 

EiceDRIVERTM SIL

1EDI2004AS

Specification

5.3

Operating range

The following operating conditions must not be exceeded in order to ensure correct operation of the

1EDI2004AS. All parameters specified in the following sections refer to these operating conditions, unless

otherwise noticed.

Table 41 Operating Conditions

Parameter

Symbol

Values

Unit Note or Test Condition

Min. Typ. Max.

Junction temperature

TJUNC -40

-

150

°C

Positive power supply (primary) VCC1

4.65

5.0

5.5

V

Referenced to GND11)

Positive power supply (secondary) VCC2

13.5

16.5

18.0

V

Referenced to GND22)

Negative power supply

VEE2

-10.0 -4.0

0.3

V

Referenced to GND2

PWM switching frequency

fsw

-

-

Common Mode Transient Immunity dVISO/dt -50

-

30

kHz 3)

50

kV/μs At 500 V4)

1) Deterministic and correct operation of the device is ensured down to VUVLO1L.

2) Deterministic and correct operation of the device is ensured down to VUVLO2L and up to 28V.

3) Maximum junction temperature of the device must not be exceeded.

4) Not subject to production test. This parameter is verified by design / characterization.

5.4

Thermal Characteristics

The indicated thermal parameters apply to the full operating range, unless otherwise specified.

Table 42 Thermal Characteristics

Parameter

Symbol

Values

Unit Note or Test Condition

Min. Typ. Max.

Thermal Resistance Junction to

Ambient

RTHJA

-

60

-

K/W Tamb=25°C1)2)

Thermal Resistance Junction to

RTHJCBOT -

-

41

K/W Tamb=25°C1)3)

Case (bottom)

Thermal Resistance Junction to

RTHJCTOP -

-

36

K/W Tamb=25°C1)4)

Case (top)

Ψ - Pseudo Thermal Resistance

RPSIJT

-

-

3

K/W Tamb=25°C1)5)

Junction to Case (top)

1) Not subject to production test. This parameter is verified by design / characterization.

2) Specified RTHJA value is according to JESD51-2 at natural convection on JEDEC 2s2p board in JESD51-2 box.

3) Specified RTHJCBOT value is according to JESD51-14 with temperature controlled heat-sink at case bottom without any

board [TJ = RTHJCBOT ×(PDIS1 + PDIS2) + Tamb].

4) Specified RTHJCTOP value is according to to JESD51-14 with temperature controlled heat-sink at case top without any

board [TJ = RTHJCTOP ×(PDIS1 + PDIS2) + Tamb].

5) Specified RPSIJT value is according to JESD51-2 at natural convection on JEDEC 2s2p board in JESD51-2 box.

[TJ=RPSIJT× (PDIS1 + PDIS2) + TTOP].

Data Sheet

122

Rev. 2.0

2019-01-16

Share Link: