AT91SAM7SE32-AU(2008) Ver la hoja de datos (PDF) - Atmel Corporation

Número de pieza

componentes Descripción

Fabricante

AT91SAM7SE32-AU
(Rev.:2008)

Product Description

Atmel Corporation 

AT91SAM7SE512/256/32 Preliminary Summary

5. Power Considerations

5.1 Power Supplies

The AT91SAM7SE512/256/32 has six types of power supply pins and integrates a voltage regu-

lator, allowing the device to be supplied with only one voltage. The six power supply pin types

are:

• VDDIN pin. It powers the voltage regulator and the ADC; voltage ranges from 3.0V to 3.6V,

3.3V nominal.

• VDDOUT pin. It is the output of the 1.8V voltage regulator.

• VDDIO pin. It powers the I/O lines; two voltage ranges are supported:

– from 3.0V to 3.6V, 3.3V nominal

– or from 1.65V to 1.95V, 1.8V nominal.

• VDDFLASH pin. It powers the USB transceivers and a part of the Flash. It is required for the

Flash to operate correctly; voltage ranges from 3.0V to 3.6V, 3.3V nominal.

• VDDCORE pins. They power the logic of the device; voltage ranges from 1.65V to 1.95V,

1.8V typical. It can be connected to the VDDOUT pin with decoupling capacitor. VDDCORE

is required for the device, including its embedded Flash, to operate correctly.

• VDDPLL pin. It powers the oscillator and the PLL. It can be connected directly to the

VDDOUT pin.

In order to decrease current consumption, if the voltage regulator and the ADC are not used,

VDDIN, ADVREF, AD4, AD5, AD6 and AD7 should be connected to GND. In this case VDDOUT

should be left unconnected.

No separate ground pins are provided for the different power supplies. Only GND pins are pro-

vided and should be connected as shortly as possible to the system ground plane.

5.2 Power Consumption

The AT91SAM7SE512/256/32 has a static current of less than 60 µA on VDDCORE at 25°C,

including the RC oscillator, the voltage regulator and the power-on reset when the brownout

detector is deactivated. Activating the brownout detector adds 20 µA static current.

The dynamic power consumption on VDDCORE is less than 80 mA at full speed when running

out of the Flash. Under the same conditions, the power consumption on VDDFLASH does not

exceed 10 mA.

5.3 Voltage Regulator

The AT91SAM7SE512/256/32 embeds a voltage regulator that is managed by the System

Controller.

In Normal Mode, the voltage regulator consumes less than 100 µA static current and draws 100

mA of output current.

The voltage regulator also has a Low-power Mode. In this mode, it consumes less than 20 µA

static current and draws 1 mA of output current.

Adequate output supply decoupling is mandatory for VDDOUT to reduce ripple and avoid oscil-

lations. The best way to achieve this is to use two capacitors in parallel:

13

6222ES–ATARM–04-Jan-08

Share Link: