LX1745
TM
®
Triple Output Boost – LED Driver / LCD Bias
PRODUCTION DATASHEET
EVALUATION BOARD
Jumper
Table 3: Jumper Position Assignments
Position
Function
JU1
N/A
Remove the factory installed jumper and insert a 4~6cm wire loop
JU2
N/A
(optional) to observe the inductor current waveform using a current
probe.
JU3
N/A
JU4
N/A
Remove jumper to test open-circuit over-voltage protection implemented
with R1 and R2
Note: All pins are referenced to ground.
Table 4: Factory Installed Component List
Ref
Part Description
C1
CAPACITOR, 4.7μF, 1210, 6.3V
C2, C5, C6 CAPACITOR, 4.7μF, 1210, 35V
C3, C7, C8 CAPACITOR, 1000pF, 0805, 35V
C4, C11 CAPACITOR, (SPARE), See Note 1
C9, C10, C12,
C13
CAPACITOR, 1μF, 0805, 35V
CR1, CR2,
CR3, CR4, CR5
Microsemi UPS5819, SCHOTTKY, 1A, 40V, POWERMITE
LED1, LED2,
LED3, LED4
Microsemi UPWLEDxx, LED, Optomite
L1, L2, L3 INDUCTOR, 47μH, 480mA, SMT
Q1
FDV303N MOSFET, 30V, SOT-23
R1, R5
RESISTOR, 1M, 1/16W, 0805
R2, R6, R8 RESISTOR, 75K, 1/16W, 0805
R3
RESISTOR, 15, 1/16W, 0805
R4
RESISTOR, 4.02K, 1/16W, 0805
R7
RESISTOR, 1.25M, 1/16W, 0805
R9, R10, R11 RESISTOR, 10K, 1/16W, 0805
R12, R13 RESISTOR, 100K, 1/16W, 0805
U1
Microsemi LX1745CPW BOOST CONTROLLER
Notes
1. Use these locations to insert additional input and/or output capacitance.
Copyright © 2000
Rev. 1.2, 2006-02-27
Microsemi
Integrated Products Division
11861 Western Avenue, Garden Grove, CA. 92841, 714-898-8121, Fax: 714-893-2570
Page 12