HIP4020 Ver la hoja de datos (PDF) - Renesas Electronics
Número de pieza
componentes Descripción
Fabricante
HIP4020 Datasheet PDF : 10 Pages
| |||
HIP4020
HIP4020
Electrical Specifications
PARAMETER
Thermal Shutdown
Response Time: VEN to VOUT
Turn-On: Prop Delay
Rise Time
Turn-Off: Prop Delay
Fall Time
TA = 25°C, VDD = +5V, VSSA = VSSB = VSS = 0V, Unless Otherwise Specified (Continued)
SYMBOL
TEST CONDITIONS
MIN
TYP
MAX
TSD
tPLH
IO = 0.5A (Note 3)
-
145
-
-
2.5
-
tr
tPHL
tf
-
4
-
-
0.1
-
-
0.1
-
UNITS
°C
s
s
s
s
Pin Descriptions
PIN NUMBER
SYMBOL
DESCRIPTION
12, 19
15
VDD
VSSA
Positive Power Supply pins; internally common and externally connect to the same Positive Supply (V+).
Negative Power Supply pin; Negative or Ground return for Switch Driver A; externally connect to the Supply
(V-).
16
VSSB
Negative Power Supply pin; Negative or Ground return for Switch Driver B; externally connect to the Supply
(V-).
6
VSS
Common Ground pin for the Input Logic Control circuits. May be used as a common ground with VSSA and
VSSB .
8, 5
A1, B1
Input pins used to control the direction of output load current to/from OUTA and OUTB, respectively. When
connected, A1 and B1 can be controlled from the same logic signal to change the directional rotation of a
motor.
9, 3
A2, B2
Input pins used to force a low state on OUTA and OUTB, respectively. When connected, A2 and B2 can be
controlled from the same logic signal to activate Dynamic Braking of a motor.
7, 4
ENA, ENB Input pins used to Enable Switch Driver A and Switch Driver B, respectively. When Low, the respective
output is in a high impedance (Z) off-state. Since each Switch Driver is independently controlled, OUTA and
OUTB may be a separately PWM controlled as Half H-Switch Drivers.
14, 17
OUTA, OUTB Respectively, Switch Driver A and Switch Driver B Output pins.
2
ILF
Current Limiting Fault Output Flag pin; when in a high logic state, signifies that Switch Driver A or B or both
are in a Current Limiting Fault Mode.
FN3976 Rev 4.00
September 17, 2015
Page 4 of 10
Share Link: 