ESDA17P50-1U1M Ver la hoja de datos (PDF) - STMicroelectronics

Número de pieza

componentes Descripción

Fabricante

ESDA17P50-1U1M

High power transient voltage suppressor

STMicroelectronics 

Recommendation on PCB assembly

3.3

Placement

ESDA17P50-1U1M

1. Manual positioning is not recommended.

2. It is recommended to use the lead recognition capabilities of the placement system,

not the outline centering

3. Standard tolerance of ±0.05 mm is recommended.

4. 3.5 N placement force is recommended. Too much placement force can lead to

squeezed out solder paste and cause solder joints to short. Too low placement force

can lead to insufficient contact between package and solder paste that could cause

open solder joints or badly centered packages.

5. To improve the package placement accuracy, a bottom side optical control should be

performed with a high resolution tool.

6. For assembly, a perfect supporting of the PCB (all the more on flexible PCB) is

recommended during solder paste printing, pick and place and reflow soldering by

using optimized tools.

3.4

PCB design preference

1. To control the solder paste amount, the closed via is recommended instead of open

vias.

2. The position of tracks and open vias in the solder area should be well balanced. A

symmetrical layout is recommended, to avoid any tilt phenomena caused by

asymmetrical solder paste due to solder flow away.

3.5

Reflow profile

Figure 17: ST ECOPACK® recommended soldering reflow profile for PCB mounting

Minimize air convection currents in the reflow oven to avoid component

movement.

8/10

Doc029464 Rev 1

Share Link: