MK712STR Ver la hoja de datos (PDF) - Integrated Circuit Systems

Número de pieza

componentes Descripción

Fabricante

MK712STR

Touch Screen Controller

Integrated Circuit Systems 

I CR O C LOC K

MK712

Touch Screen Controller

Analog to Digital Converter Operation

The 12-bit ADC converts X and Y co-ordinates at a rate determined by registers 6 and 7. The

converter uses a ratiometric technique to give absolute co-ordinates on the screen, largely independent

of variations in screen resistance, temperature or power supply voltage. The total voltage applied across

the screen is defined as full-scale for the converter (i.e. 4095) and any point touched on the screen is

proportional to this. For example, if the screen is touched exactly in the center, the converter will read

2047. This feature may allow for the elimination of calibration upon startup.

However, the full scale voltage is defined at the IC pins and so any parasitic interconnect resistance will

be included in full scale. In addition, the interconnect resistances on the screen also account for about

20% of the total resistance. This means that approximately the bottom 10% and top 10% of full scale

are inaccessible.

The converter is guaranteed to be monotonic, with no missing codes.

XH

MK712

YL

XL

BOARD AND WIRE

INTERCONNECT

FULL

SCALE

(4095)

SCREEN

INTERCONNECT

SCREEN

X

CO-ORDINATE

SCREEN

INTERCONNECT

BOARD AND WIRE

INTERCONNECT

MDS 712 I

9

Revision 100899 Printed 11/16/00

Integrated Circuit Systems, Inc.•525 Race St.•San Jose•CA•95126•(408)295-9800tel•www.icst.com

Share Link: