RTL8111 Ver la hoja de datos (PDF) - Realtek Semiconductor

Número de pieza

componentes Descripción

Fabricante

RTL8111

INTEGRATED GIGABIT ETHERNET CONTROLLER FOR PCI EXPRESS™ APPLICATIONS

Realtek Semiconductor 

RTL8111

Datasheet

6.4. Next Page

If 1000Base-T mode is advertised, three additional Next Pages are automatically exchanged between the

two link partners. Users can set PHY Reg4.15 to 1 to manually exchange extra Next Pages via Reg7 and

Reg8 as defined in IEEE 802.3ab.

6.5. EEPROM Interface

The RTL8111 requires the attachment of an external EEPROM. The 93C46/93C56 is a 1K-bit/2K-bit

EEPROM. The EEPROM interface permits the RTL8111 to read from, and write data to, an external serial

EEPROM device.

Values in the external EEPROM allow default fields in PCI configuration space and I/O space to be

overridden following a power-on or software EEPROM auto-load command. The RTL8111 will auto-load

values from the EEPROM. If the EEPROM is not present, the RTL8111 initialization uses default values

for the appropriate Configuration and Operational Registers. Software can read and write to the EEPROM

using bit-bang accesses via the 9346CR Register, or using PCI VPD (Vital Product Data). The interface

consists of EESK, EECS, EEDO, and EEDI.

EEPROM

EECS

EESK

EEDI/Aux

EEDO

Table 10. EEPROM Interface

Description

93C46/93C56 chip select.

EEPROM serial data clock.

Input data bus/Input pin to detect if Aux. Power exists on initial power-on.

This pin should be connected to EEPROM. To support wakeup from ACPI D3cold or APM

power-down, this pin must be pulled high to Aux. Power via a resistor. If this pin is not

pulled high to Aux. Power, the RTL8111 assumes that no Aux. Power exists.

Output data bus.

Integrated Gigabit Ethernet Controller for PCI Express 12

Track ID: JATR-1076-21 Rev. 1.2

Share Link: