Data Sheet
ADF7023
GENERAL SPECIFICATIONS
Table 6.
Parameter
TEMPERATURE RANGE, TA
VOLTAGE SUPPLY
VDD
TRANSMIT CURRENT CONSUMPTION
Single-Ended PA, 433 MHz
−10 dBm
0 dBm
10 dBm
13.5 dBm
Differential PA, 433 MHz
−10 dBm
0 dBm
5 dBm
10 dBm
Single-Ended PA, 868 MHz/915 MHz
−10 dBm
0 dBm
10 dBm
13.5 dBm
Differential PA, 868 MHz/915 MHz
−10 dBm
0 dBm
5 dBm
10 dBm
POWER MODES
PHY_SLEEP (Deep Sleep Mode 2)
PHY_SLEEP (Deep Sleep Mode 1)
PHY_SLEEP (RCO Wake Mode)
PHY_SLEEP (XTO Wake Mode)
PHY_OFF
PHY_ON
PHY_RX
SMART WAKE MODE
Min Typ Max Unit Test Conditions
−40
+85 °C
2.2
3.6 V
Applied to VDDBAT1 and VDDBAT2
In the PHY_TX state, single-ended PA matched to 50 Ω,
differential PA matched to 100 Ω, separate single-ended
PA and LNA match, combined differential PA and LNA
match
8.7
mA
12.2
mA
23.3
mA
32.1
mA
7.9
mA
11
mA
15
mA
22.6
mA
10.3
mA
13.3
mA
24.1
mA
32.1
mA
9.3
mA
12
mA
16.7
mA
28
mA
0.18
0.33
0.75
1.28
1
1
12.8
21.78
11.75
µA Sleep mode, wake-up configuration values (BBRAM) not
retained
µA Sleep mode, wake-up configuration values (BBRAM)
retained
µA WUC active, RC oscillator running, wake-up configuration
values retained (BBRAM)
µA WUC active, 32 kHz crystal running, wake-up configuration
values retained (BBRAM)
mA Device in PHY_OFF state, 26 MHz oscillator running, digital
and synthesizer regulators active, all register values
retained
mA Device in PHY_ON state, 26 MHz oscillator running, digital,
synthesizer, VCO, and RF regulators active, baseband filter
calibration performed, all register values retained
mA Device in PHY_RX state
Average current consumption
µA Autonomous reception every 1 sec, with receive dwell
time of 1.25 ms, using RC oscillator, data rate = 38.4 kbps
µA Autonomous reception every 1 sec, with receive dwell
time of 0.5 ms, using RC oscillator, data rate = 300 kbps
Rev. C | Page 15 of 112