STK554U362A-E Ver la hoja de datos (PDF) - ON Semiconductor
Número de pieza
componentes Descripción
Fabricante
STK554U362A-E Datasheet PDF : 15 Pages
| |||
STK554U362A-E
Parameter
Symbol
Conditions
Switching Character
Switching time
t ON
t OFF
Io = 10 A
Inductive load
Turn-on switching loss
Turn-off switching loss
Total switching loss
Eon
Io = 5 A,V+ = 300 V,
Eoff
VDD = 15 V, L = 650 H
Etot
Tc = 25C
Turn-on switching loss
Turn-off switching loss
Total switching loss
Eon
Io = 5 A, V+ = 300 V,
Eoff
VDD = 15 V, L = 650 H
Etot
Tc = 100C
Diode reverse recovery energy
Diode reverse recovery time
Erec
trr
I0 = 5 A, V+ = 400 V, VDD = 15 V,
L = 650 H, Tc = 100C
Reverse bias safe operating area
Short circuit safe operating area
RBSOA
SCSOA
Io = 20 A, VCE = 450 V
VCE = 400 V, Tc = 100C
Allowable offset voltage slew rate
dv/dt
Between U(V,W) to U-(V-,W-)
Reference voltage is “VSS” terminal voltage unless otherwise specified.
Test
circuit
Fig.5
Min Typ
Max
0.4
0.65
130
122
252
156
154
310
6.9
57
Full square
4
50
50
Unit
μs
μJ
μJ
μJ
μJ
μJ
μJ
μJ
ns
μs
V/ns
Product parametric performance is indicated in the Electrical Characteristics for the listed test conditions, unless otherwise noted. Product performance may not be
indicated by the Electrical Characteristics if operated under different conditions.
Notes
1. The pre-drive power supply low voltage protection has approximately 200 mV of hysteresis and operates as follows.
Upper side : The gate is turned off and will return to regular operation when recovering to the normal voltage, but the latch will
continue till the input signal will turn ‘low’.
Lower side : The gate is turned off and will automatically reset when recovering to normal voltage. It does not depend on input signal
voltage.
2. When assembling the IPM on the heat sink the tightening torque range is 0.6 Nm to 0.9 Nm.
3. The pre-drive low voltage protection protects the device when the pre-drive supply voltage falls due to an operating malfunction.
4. When use the over-current protection with external shunt resistor, please set the current protection level to be equal to or less than the
rating of output peak current (Iop).
www.onsemi.com
3
Share Link: 