TOOLSTICK326PP Ver la hoja de datos (PDF) - Unspecified

Número de pieza

componentes Descripción

Fabricante

TOOLSTICK326PP

ToolStick Programming Adapter

Unspecified 

ToolStick Programming Adapter

5. Software Installation Instructions

This section describes how to download and install the Silicon Labs MCU Production Programmer. This program is

used to download the firmware to the target MCU from a Windows PC.

Step 1. Download the MCU Production Programmer from

https://www.silabs.com/products/mcu/Pages/SoftwareDownloads.aspx.

Step 2. Install the program by running the executable and following the on-screen

instructions.

Step 3. Start the program from Start  All Programs  Silicon Laboratories  MCU

Production Programmer.

Step 4. Connect the ToolStick to the socket daughter card, and connect it to the PC.

Step 5. Go to Program Menu  Configure Programming Information.

Step 6. Configure the required programming settings.

The required settings are Part Number, Debug Adapter, and Hex File. Configuration of the other,

optional settings should be also done during this step.

Note: The ToolStick might not appear as a "Debug Adapter" selection until the MCU is inserted into the

socket and the switch on the daughter card is set to the ON position. See Section 6 for hardware usage

instructions.

Figure 4. Configure Programming Settings

Step 7. Save these settings to a file using the "Save Settings" button.

Whenever the program is started, the settings saved in Step 7 can be restored using the "Load Settings"

button in this same menu.

Rev. 0.3

3

Share Link: