M1A3P250-TQG144PP Ver la hoja de datos (PDF) - Unspecified

Número de pieza

componentes Descripción

Fabricante

M1A3P250-TQG144PP

1 – ProASIC®3 Flash Family FPGAs with Optional Soft ARM Support

Unspecified 

ProASIC3 DC and Switching Characteristics

2 – ProASIC3 DC and Switching Characteristics

General Specifications

DC and switching characteristics for –F speed grade targets are based only on simulation.

The characteristics provided for the –F speed grade are subject to change after establishing FPGA

specifications. Some restrictions might be added and will be reflected in future revisions of this

document. The –F speed grade is only supported in the commercial temperature range.

Operating Conditions

Stresses beyond those listed in Table 2-1 may cause permanent damage to the device.

Exposure to absolute maximum rating conditions for extended periods may affect device reliability.

Absolute Maximum Ratings are stress ratings only; functional operation of the device at these or

any other conditions beyond those listed under the Recommended Operating Conditions specified

in Table 2-2 on page 2-2 is not implied.

Table 2-1 • Absolute Maximum Ratings

Symbol

Parameter

Limits

Units

VCC

DC core supply voltage

–0.3 to 1.65

V

VJTAG JTAG DC voltage

–0.3 to 3.75

V

VPUMP Programming voltage

–0.3 to 3.75

V

VCCPLL Analog power supply (PLL)

–0.3 to 1.65

V

VCCI

DC I/O output buffer supply voltage

–0.3 to 3.75

V

VMV DC I/O input buffer supply voltage

–0.3 to 3.75

V

VI

I/O input voltage

–0.3 V to 3.6 V

V

(when I/O hot insertion mode is enabled)

–0.3 V to (VCCI + 1 V) or 3.6 V, whichever voltage is lower

(when I/O hot-insertion mode is disabled)

TSTG 2

TJ 2

Storage temperature

Junction temperature

–65 to +150

°C

+125

°C

Notes:

1. The device should be operated within the limits specified by the datasheet. During transitions, the input

signal may undershoot or overshoot according to the limits shown in Table 2-4 on page 2-3.

2. For flash programming and retention maximum limits, refer to Table 2-3 on page 2-2, and for

recommended operating limits, refer to Table 2-2 on page 2-2.

v1.1

2-1

Share Link: