Multimedia ICs
BA7786FP-Y / BA7787FS
BA7787FS
No.
R1
R2
R3
R4
R5
R6
R7
R8
R9
R10
R11
R12
R13
R14
R15
C1
C2
C3
C4
C5
C6
C7
C8
C9
C10
C11
C12
VR1
Use
Used to set the gain from LINE IN L / LINE IN R (pins 2 and 4) to HP OUT
L / HP OUT R (pins 19 and 18) (See section 1, on circuit operation for the formula.)
A wide range of mixing ratios can be set by changing the values of R1, R2 and
R3 (or R4, R5 and R6).
Resistors for mixing SYSTEM BEEP IN (pin 6). Because the threshold voltage
between the high and low levels is fixed inside the IC, these resistors should be set
to 33kΩ.
• Used to set the gain from SP IN (pin 7) to SP OUT 1 / SP OUT 2
(pins 14 and 13). (See section 3, on circuit operation for the formula.)
• Used to set the gain from PM BEEP IN (pin 8) to SP OUT 1 / SP OUT 2
(pins 14 and 13). (See section 4, on circuit operation for the formula.)
• Used to set the output level from SYSTEM BEEP IN (pin 6) to HP OUT
L / HP OUT R (pins 19 and 18). (See section 2, on circuit operation for the formula.)
• The load resistor for HP OUT R.
• The load resistor for HP OUT L.
• The coupling capacitor for LINE IN L
• The coupling capacitor for LINE IN R
• The ripple rejection capacitor for the bias pin
• The coupling capacitor for SYSTEM BEEP IN
• The coupling capacitor for SP IN
• The coupling capacitor for PM BEEP IN
• The bypass capacitor for SP VCC (used for low-frequency ripple rejection)
• The bypass capacitor for SP VCC (used for high-frequency ripple rejection)
• The coupling capacitor for HP OUT R
• The coupling capacitor for HP OUT L
• The bypass capacitor for HP VCC (used for low-frequency ripple rejection)
• The bypass capacitor for HP VCC (used for high-frequency ripple rejection)
• Used to change the pin 1 DC voltage
Standard value
27kΩ
27kΩ
27kΩ
27kΩ
27kΩ
27kΩ
33kΩ
33kΩ
33kΩ
15kΩ
15kΩ
18kΩ
390kΩ
100Ω
100Ω
0.1µF
0.1µF
47µF
0.1µF
0.1µF
0.1µF
100µF
0.1µF
47µF
47µF
100µF
0.1µF
20kΩ
18