EN5336QI-T Ver la hoja de datos (PDF) - Enpirion, Inc.
Número de pieza
componentes Descripción
Fabricante
EN5336QI-T Datasheet PDF : 13 Pages
| |||
Rev 1.2 October 2008
EN5336QI
Pin Descriptions
PIN
1-3
4-6
7
8-14
15
16
17-20
21-24
25-26
27
28
29
30-31
32
33
34
35
36
37
38
39
40
41
42-44
NAME
NC
NC(SW)
NC
VOUT
NC(SW)
NC
PGND
PVIN
NC
ROCP
AVIN
AGND
NC
XFB
XOV
NC
POK
NC
SS
EAIN
EAOUT
COMP
ENABLE
NC
FUNCTION
NO CONNECT – Do not electrically connect these pins to each other or to
PCB.
No Connect. These pins are internally connected to the switch node of the
internal MOSFETs. NC(SW) pins are not to be electrically connected to any
external signal, ground, or voltage.
No connect – Do not electrically connect these pins to each other or to PCB.
Regulated converter output. Connect these pins to the load and place output
capacitor from these pins the PGND pins 17-18
No Connect. These pins are internally connected to the switch node of the
internal MOSFETs. NC(SW) pins are not to be electrically connected to any
external signal, ground, or voltage.
No connect – Do not electrically connect these pins to each other or to PCB.
Output power ground. Connect these pins to the ground electrode of the
output filter capacitors. Refer to layout guideline section.
Input power supply. Connect to input power supply. Decouple with input
capacitor to PGND (pins 19-20).
No connect – Do not electrically connect these pins to each other or to PCB.
Optional Over Current Protection adjust pin. Place ROCP resistor between
this pin and AGND (pin 40) to increase the over current trip point by 50%.
Analog voltage input for the controller circuits. Connect this pin to the input
power supply.
Analog ground for the controller circuits.
No connect – Do not electrically connect these pins to each other or to PCB.
Voltage Feedback pin for external voltage divider network.
Optional Over-Voltage Programming Feedback pin.
No connect – Do not electrically connect these pins to each other or to PCB.
Power OK is an open drain transistor for power system state indication. POK
is a logic high when VOUT is with -10% to +20% of VOUT nominal.
No connect – Do not electrically connect these pins to each other or to PCB.
Soft-Start node. The soft-start capacitor is connected between this pin and
AGND. The value of this resistor determines the startup timing.
Optional Error Amplifier input. Allows for customization of the control loop.
Optional Error Amplifier output. Allows for customization of the control loop.
Optional Error Amplifier Buffer output. Allows for customization of the control
loop.
Input Enable. Applying a logic high, enables the output and initiates a soft-
start. Applying a logic low disables the output.
No connect – Do not electrically connect these pins to each other or to PCB.
Enpirion 2008 all rights reserved, E&OE
3
www.enpirion.com
Share Link: 