WM8602SEDS/RV Ver la hoja de datos (PDF) - Wolfson Microelectronics plc

Número de pieza

componentes Descripción

Fabricante

WM8602SEDS/RV

2.1 Channel PWM Controller

Wolfson Microelectronics plc 

Product Preview

WM8602

Test Conditions

AVDD, BVDD, DVDD = 2.7 to 3.3V, AGND, DGND, BGND = 0V, TA = -20 to +85oC, fs = 44.1kHz/48kHz, MCLK = 256fs unless

stated.

PARAMETER

PWM buffer drive strength

SYMBOL

Isource

Isink

TEST CONDITIONS

CMOS

20pF load

MIN

254

254

TYP

MAX

UNIT

mA

mA

PWM pulse repetition rate

fPWM

fs = 44.1kHz

352.8

kHz

fs = 48kHz

384

kHz

Notes:

1. Ratio of output level with 1kHz full scale input, to the output level with all zeros into the digital input, measured ‘A’

weighted over a 20Hz to 20kHz bandwidth.

2. All performance measurements done with 20kHz AES17 low pass filter, except where noted an A-weight filter is used.

Failure to use such a filter will result in higher THD+N and lower SNR and Dynamic Range readings than are found in

the Electrical Characteristics. The low pass filter removes out of band noise; although it is not audible it may affect

dynamic specification values.

3. The XIN input supports both a clock as well as a crystal input.

4. Parameter guaranteed by design.

5. Validated using the following filter

PARAMETER

Filter

Stopband

SYMBOL TEST CONDITIONS

MIN

-3dB

TYP

1.00

MAX

UNIT

kHz

Note: A third order differential RC filter has been used

TERMINOLOGY

1. Signal-to-noise ratio (dB) - SNR is a measure of the difference in level between the full scale output and the output

with no signal applied.

2. Dynamic range (dB) - DNR is a measure of the difference between the highest and lowest portions of a signal.

Normally a THD+N measurement at 60dB below full scale. The measured signal is then corrected by adding the 60dB

to it (e.g. THD+N @ -60dB= -32dB, DR= 92dB).

3. THD+N (dB) - THD+N is a ratio, of the RMS values, of (Noise + Distortion)/Signal.

POWER CONSUMPTION

MODE DESCRIPTION

TYPICAL SUPPLY CURRENTS

[mA]

AVDD, DVDD, BVDD = 3.3V

OFF

Standby

Mute

Stereo

2.1

IAVDD

0

0.02

1.76

1.76

Table 1 Supply Current Consumption

IDVDD

0

0.28

27.2

27.7

IBVDD

0

0

7.55

7.55

TOTAL CURRENT

[mA]

0

0.30

36.5

37.0

TOTAL POWER

[mW]

0

0.99

121

122

Notes:

1. TA = +25oC, Slave Mode, fs = 48kHz, MCLK = 27 kHz, 24-bit data

2. All figures are kHz 1kHz input sine wave @ 0dB.

w

PP Rev 1.5 May 2004

7

Share Link: