25X10ALAIZ Ver la hoja de datos (PDF) - Winbond

Número de pieza

componentes Descripción

Fabricante

25X10ALAIZ

1M-BIT, 2M-BIT, 4M-BIT AND 8M-BIT 2.5V SERIAL FLASH MEMORY WITH 4KB SECTORS AND DUAL OUTPUT SPI

Winbond 

W25X10AL, W25X20AL, W25X40AL, W25X80AL

10.2.16 Read Manufacturer / Device ID (90h)

The Read Manufacturer/Device ID instruction is an alternative to the Release from Power-down/

Device ID instruction that provides both JEDEC assigned manufacturer ID and the specific device ID.

The Read Manufacturer/Device ID instruction is very similar to the Release from Power-down / Device

ID instruction. The instruction is initiated by driving the /CS pin low and shifting the instruction code

“90h” followed by a 24-bit address (A23-A0) of 000000h. After which, the Manufacturer ID for Winbond

(EFh) and the Device ID are shifted out on the falling edge of CLK with most significant bit (MSB) first

as shown in figure 18. The Device ID values for the W25X10AL, W25X20AL, W25X40AL and

W25X80AL are listed in Manufacturer and Device Identification table. If the 24-bit address is initially

set to 000001h the Device ID will be read first and then followed by the Manufacturer ID. The

Manufacturer and Device IDs can be read continuously, alternating from one to the other. The

instruction is completed by driving /CS high.

Figure 18. Read Manufacturer / Device ID Diagram

- 29 -

Publication Release Date: May 9, 2008

Revision B

Share Link: