TLP116A(2019) Ver la hoja de datos (PDF) - Toshiba
Número de pieza
componentes Descripción
Fabricante
TLP116A Datasheet PDF : 7 Pages
| |||
Absolute Maximum Ratings (Ta=25°C)
TLP116A
Characteristic
Symbol Rating
Unit
Forward current
Forward current derating (Ta ≥ 85°C)
Peak transient forward current (Note 1)
Reverse voltage
Input power dissipation
Input power dissipation derating (Ta ≥ 85°C)
Output current
Output current derating (Ta ≥ 85°C)
Output voltage
Supply voltage
Output power dissipation
Operating temperature range
Storage temperature range
Lead solder temperature(10 s)
Isolation voltage (AC,60 s, R.H. ≤ 60 %)
(Note 2)
IF
ΔIF / °C
IFPT
VR
PD
ΔPD/°C
IO
ΔIO/°C
VO
VCC
PO
Topr
Tstg
Tsol
BVs
20
−0.5
1
5
40
-1.0
10
-0.25
6
6
40
−40 to 100
−55 to 125
260
3750
mA
mA/°C
A
V
mW
mW/°C
mA
mA/°C
V
V
mW
°C
°C
°C
Vrms
Note:
Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even
if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum
ratings and the operating ranges. Please design the appropriate reliability upon reviewing the Toshiba
Semiconductor Reliability Handbook (“Handling Precautions”/“Derating Concept and Methods”) and individual
reliability data (i.e. reliability test report and estimated failure rate, etc).
Note 1 : Pulse width PW ≤ 1 μs, 300 pps.
Note 2 :This device is regarded as a two terminal device : pins 1 and 3 are shorted together, as are pins 4,5 and 6.
Recommended Operating Conditions
Characteristic
Input current ON
Input voltage , OFF
Supply voltage
Operating temperature
Symbol
Min
Typ.
Max
Unit
IF(ON)
8
VF(OFF)
0
—
18
mA
—
0.8
V
VCC
4.5
5.0
5.5
V
Topr
-40
—
100
°C
Note: Recommended operating conditions are given as a design guideline to obtain expected performance of the
device. Additionally, each item is an independent guideline respectively. In developing designs using this product,
please confirm specified characteristics shown in this document.
Note:
The detector of this product requires a power supply voltage (VCC) of 4.5 V or higher for stable operation.
If the VCC is lower than this value, an ICC may increase, or an output may be unstable.
Be sure to use the product after checking the supply current, and the operation of a power-on/-off.
Correlation between Input current, switching speed and drive circuit
(reference information).
Input current
(IF)
12mA
8mA
8mA
Test Circuit
1
(Page 4)
1
(Page 4)
2
(Page 4, With Speed up capacitor)
Typical switching speed
21 to 23 MBd
18 to 20 MBd
23 to 27 MBd
© 2019
2
Toshiba Electronic Devices & Storage Corporation
2019-10-10
Share Link: 