HTSSOP32 Ver la hoja de datos (PDF) - NXP Semiconductors.
Número de pieza
componentes Descripción
Fabricante
HTSSOP32 Datasheet PDF : 48 Pages
| |||
NXP Semiconductors
TDA8932B
Class-D audio amplifier
14.2 Output current limiting
The peak output current IO(max) is internally limited above a level of 4 A (minimum). During
normal operation the output current should not exceed this threshold level of 4 A
otherwise the output signal is distorted. The peak output current in SE or BTL
configurations can be estimated using Equation 5 and Equation 6.
SE configuration:
IO(max) ≤ -R----L----+-----R---D---0-S--.-o5--n---×-+---V--R---P-s---+-----R----E---S---R- ≤ 4 A
(5)
BTL configuration:
IO(max) ≤ -R----L----+----2-----×-----(-V-R----PD----S--o---n----+-----R----s--) ≤ 4 A
(6)
Where:
VP = supply voltage VDDP1 − VSSP1 (V) or VDDP2 − VSSP2 (V)
RL = load impedance (Ω)
RDSon = on-resistance power switch (Ω)
Rs = series resistance output inductor (Ω)
RESR = equivalent series resistance SE capacitor (Ω)
Example:
A 4 Ω speaker in the BTL configuration can be used up to a supply voltage of 18 V without
running into current limiting. Current limiting (clipping) will avoid audio holes but it causes
a comparable distortion like voltage clipping.
14.3 Speaker configuration and impedance
For a flat frequency response (second-order Butterworth filter) it is necessary to change
the low-pass filter components Llc and Clc according to the speaker configuration and
impedance. Table 14 shows the practical required values.
Table 14. Filter component values
Configuration
SE
RL (Ω)
4
6
8
BTL
4
6
8
Llc (µH)
22
33
47
10
15
22
Clc (nF)
680
470
330
1500
1000
680
14.4 Single-ended capacitor
The SE capacitor forms a high-pass filter with the speaker impedance. So the frequency
response will roll-off with 20 dB per decade below f-3dB (3 dB cut-off frequency).
TDA8932B_4
Product data sheet
Rev. 04 — 18 December 2008
© NXP B.V. 2008. All rights reserved.
24 of 48
Share Link: 