STK672-120-SL-E Ver la hoja de datos (PDF) - SANYO -> Panasonic

Número de pieza

componentes Descripción

Fabricante

STK672-120-SL-E

2-phase Stepping Motor Driver

SANYO -> Panasonic 

STK672-120-SL-E

Usage Notes

• 5V system input pins

[RESETB and CLOCK 〈〈Input signal timing when power is first applied〉〉]

As shown in the timing chart, a RESETB signal input is required by the driver to operate with the timing in which the

F1 gate is turned on first. The RESETB signal timing must be set up to have a width of at least 20μs, as shown below.

The capacitor CO4 and the resistor RO3 in the application circuit form simple reset circuit that uses the RC time

constant rising time. However, when designing the RESETB input based on CMOS levels, the application must have

the timing shown in figure 2.

Rise of the 5V supply voltage

RESETB signal input

CLOCK signal

At least 20μs

At least 10μs

Figure 2 RESETB and CLOCK Signals Input Timing

See the timing chart for details on the CLOCK, MODE, CWB, and other input pins.

[Vref 〈〈Motor current peak value setting〉〉]

In the sample application circuit, the peak value of the motor current (IOH) is set by RO1, RO2, and VDD (5V) as

described by the formula below.

IOH

0

Figure 3 Motor Current IO Flowing into the Driver IC

IOH = Vref÷Rs Here, Rs is hybrid IC internal current detection resistor

Vref = (RO2÷ (RO1+RO2)) ×5V

STK672-120-SL-E: Rs = 0.165Ω

• Allowable motor current operating range

The motor current (IOH) must be held within the range corresponding to the area under the curve shown in figure 1.

For example, if the operating substrate temperature Tc is 105°C, then IOH must be held under IOH = 2.4A, and in

hold mode IOH must be held under IOH = 2.0A.

No. A2140-6/11

Share Link: