SCA10X0 Ver la hoja de datos (PDF) - VTI technologies

Número de pieza

componentes Descripción

Fabricante

SCA10X0

Assembly Instructions for SCA6x0 and SCA10x0 series

VTI technologies 

Assembly Instructions for SCA6x0 and SCA10x0 series

TN71

6 Hand Soldering Guidelines

For hand soldering of the DIL component, VTI recommends eutectic tin-lead solder due to the

lower melting point compared to lead-free solders. Key thing is that as soon as the solder flows the

soldering iron must be removed from the board. The package temperature should be kept under

280ºC (max 250ºC recommended) and all mechanical stresses in the pin should be minimized. It

should be noted, that also PCB material might damage if too much heat or force is used.

Generally the hand soldering of the DIL component can be done in two different ways:

Method A: Soldering of components with tin wire and soldering iron

Method B: Soldering by applying solder paste onto PCB land pads and then using reflow heating

or soldering iron to melt the paste and achieve the soldered joint.

METHOD A: Soldering of components with soldering iron

Use the tin wire and soldering iron to solder the component onto PCB. Do not touch the package

plastic body with the soldering iron, soldering iron should touch only the PCB pad and through that

the heat should be conducted to the tin wire and component lead. VTI has used 315ºC setting

temperature for component soldering. The temperature on the tip of the tool is 270...275ºC.

Soldering process takes only few seconds for each pin. For leaded soldering we have used

Multicore Sn60Pb40 and for lead-free soldering Almit KR-19SHrma flux-cored solder wire.

Figure 10: Using tin wire and soldering iron for hand soldering.

METHOD B: Soldering by applying solder paste and then using reflow heating or soldering

iron

1. Apply the solder paste onto the PCB land pads. The paste can be applied by two different

methods.

• Manual solder paste printing through a stencil with normal openings designed for the

DIL component. .

• Needle dispensing of solder paste manually onto the PCB pads. VTI recommends use

of a microscope in manual solder paste dispensing. Dispensing needle tip size can be

0.12"-0.16".

2. Place the component gently on top of the solder paste. To avoid solder bridging, push only very

gently on top of the component.

Melt the solder paste by putting the part through reflow oven or by using soldering iron as mentioned

in the previous part.

VTI Technologies Oy

www.vti.fi

9/12

Rev.1.0

Share Link: