RT8011 Ver la hoja de datos (PDF) - Richtek Technology
Número de pieza
componentes Descripción
Fabricante
RT8011 Datasheet PDF : 17 Pages
| |||
RT8011/A
resistance of COUT. ΔILOAD also begins to charge or
discharge COUT generating a feedback error signal used
by the regulator to return VOUT to its steady-state value.
During this recovery time, VOUT can be monitored for
overshoot or ringing that would indicate a stability problem.
The COMP pin external components and output capacitor
shown in Typical Application Circuit will provide adequate
compensation for most applications.
Layout Considerations
Follow the PCB layout guidelines for optimal performance
of RT8011/A.
` A ground plane is recommended. If a ground plane layer
is not used, the signal and power grounds should be
segregated with all small-signal components returning
to the GND pin at one point that is then connected to
the PGND pin close to the IC. The exposed pad should
be connected to GND.
` Connect the terminal of the input capacitor(s), CIN, as
close as possible to the PVDD pin. This capacitor
provides the AC current into the internal power
MOSFETs.
` LX node is with high frequency voltage swing and should
be kept small area. Keep all sensitive small-signal nodes
away from LX node to prevent stray capacitive noise
pick-up.
` Flood all unused areas on all layers with copper.
Flooding with copper will reduce the temperature rise
of powercomponents.
You can connect the copper areas to any DC net (PVDD,
VDD, VOUT, PGND, GND, or any other DC rail in your
system).
` Connect the FB pin directly to the feedback resistors.
The resistor divider must be connected between VOUT
and GND.
Figure 7. RT8011 Demo Board
Figure 8. RT8011A Demo Board (Only WDFN-8E 3x3)
www.richtek.com
14
DS8011/A-00 August 2006
Share Link: 