PDIUSBH11A Ver la hoja de datos (PDF) - Philips Electronics

Número de pieza

componentes Descripción

Fabricante

PDIUSBH11A

Universal Serial Bus Hub

Philips Electronics 

Philips Semiconductors

Universal Serial Bus Hub

Product specification

PDIUSBH11A

Set Mode

Command

Data

: F3h

: Write 2 bytes

The Set Mode command is followed by two data writes. The first

byte contains the configuration byte values. The second byte is the

clock division factor byte.

Configuration Byte

76 54 32 1 0

10 00 11 01

POWER ON VALUE

REMOTE WAKEUP

NO LAZYCLOCK

CLOCK RUNNING

DEBUG MODE

SoftConnect™

CONNECT DOWNSTREAM RESISTORS

NON-BLINKING LEDs

EMBEDDED FUNCTION MODE

SV00842

Remote Wakeup

No LazyClock

Clock Running

Debug Mode

SoftConnect™

A ‘1’ indicates that a remote wakeup feature

is ON. Bus reset will set this bit to ‘1’.

A ‘1’ indicates that CLKOUT will not switch

to LazyClock. A ‘0’ indicates that the

CLKOUT switches to LazyClock 1ms after

the Suspend pin goes high. LazyClock

frequency is 30 kHz (± 40%). The

programmed value will not be changed by a

bus reset.

A ‘1’ indicates that the internal clocks and

PLL are always running even during

Suspend state. A ‘0’ indicates that the

internal clock, crystal oscillator and PLL are

stopped whenever not needed. To meet the

strict Suspend current requirement, this bit

needs to be set to ‘0’. The programmed

value will not be changed by a bus reset.

A ‘1’ indicates that all errors and “NAKing”

are reported and a ‘0’ indicates that only OK

and babbling are reported. The programmed

value will not be changed by a bus reset.

A ‘1’ indicates that the upstream pull-up

resistor will be connected if VBUS is

available. A ‘0’ means that the upstream

resistor will not be connected. The

programmed value will not be changed by a

bus reset.

Connect Downstream

Resistors

A ‘1’ indicates that downstream resistors are

connected. A ‘0’ means that downstream

resistors are not connected. The

programmed value will not be changed by a

bus reset.

Non-blinking LEDs

A ‘1’ indicates that GoodLink™ LEDs will

NOT blink when there is traffic. Leave this bit

at ‘0’ to achieve blinking LEDs. The

programmed value will not be changed by a

bus reset.

Embedded Function

Mode

A ‘1’ indicates single embedded function

mode. A ‘0’ indicates multiple (3) embedded

function mode. See endpoint descriptions for

details. The programmed value will not be

changed by a bus reset.

Clock Division Factor Byte

76 54 32 1 0

XX 0 0 0 0 1 1

XX 1 1 1 0 1 1

POWER ON VALUE FOR 48MHz INPUT

POWER ON VALUE FOR 12MHz INPUT

CLOCK DIVISION FACTOR

RESERVED

SV00843

Clock Division Factor

The value indicates clock division factor for

CLKOUT. The output frequency is

48 MHz/(N+1) where N is the Clock Division

Factor. When the 48MHz input crystal

frequency is selected, the reset value is 3.

This will give a default output frequency at

CLKOUT pin of 12 MHz, thus maintaining

backward compatibility to the PDIUSBH11.

When the 12 MHz input crystal frequency is

selected, the reset value is 11. This will

produce the lowest output frequency of 4

MHz which can then be programmed up by

the user. The PDIUSBH11A design ensures

no glitching during frequency change. The

programmed value will not be changed by a

bus reset.

1999 Jul 22

12

Share Link: