ST7FSCR14M1 Ver la hoja de datos (PDF) - STMicroelectronics

Número de pieza

componentes Descripción

Fabricante

ST7FSCR14M1

8-BIT LOW-POWER, FULL-SPEED USB MCU WITH 16K FLASH, 768 RAM, SMARTCARD I/F, TIMER

STMicroelectronics 

ST7SCR

FLASH PROGRAM MEMORY (Cont’d)

Note: If the ICCCLK or ICCDATA pins are only

used as outputs in the application, no signal isola-

tion is necessary. As soon as the Programming

Tool is plugged to the board, even if an ICC ses-

sion is not in progress, the ICCCLK and ICCDATA

pins are not available for the application. If they

are used as inputs by the application, isolation

such as a serial resistor has to implemented in

case another device forces the signal. Refer to the

Programming Tool documentation for recom-

mended resistor values.

4.6 Program Memory Read-out Protection

The read-out protection is enabled through an op-

tion bit.

For Flash devices, when this option is selected,

the program and data stored in the Flash memory

are protected against read-out piracy (including a

re-write protection). When this protection is re-

moved by reprogramming the Option Byte, the en-

tire Flash program memory is first automatically

erased.

Refer to the Option Byte description for more de-

tails.

4.6.1 Register Description

FLASH CONTROL/STATUS REGISTER (FCSR)

Read /Write

Reset Value: 0000 0000 (00h)

7

0

0

0

0

0

0

0

0

0

This register is reserved for use by Programming

Tool software. It controls the FLASH programming

and erasing operations. For details on customizing

FLASH programming methods and In-Circuit Test-

ing, refer to the ST7 FLASH Programming and

ICC Reference Manual.

16/102

1

Share Link: