MPC7457EC Ver la hoja de datos (PDF) - Freescale Semiconductor

Número de pieza

componentes Descripción

Fabricante

MPC7457EC

RISC Microprocessor

Freescale Semiconductor 

Electrical and Thermal Characteristics

Table 8. Clock AC Timing Specifications (continued)

At recommended operating conditions. See Table 4.

Maximum Processor Core Frequency

Characteristic

Symbol 867 MHz

1000 MHz

1200 MHz

1267 MHz Unit Notes

Min Max Min Max Min Max Min Max

Internal PLL relock time

— 100 — 100 — 100 — 100 μs

7

Notes:

1. Caution: The SYSCLK frequency and PLL_CFG[0:4] settings must be chosen such that the resulting SYSCLK (bus)

frequency, CPU (core) frequency, and PLL (VCO) frequency do not exceed their respective maximum or minimum operating

frequencies. Refer to the PLL_CFG[0:4] signal description in Section 1.9.1, “PLL Configuration,” for valid PLL_CFG[0:4]

settings.

2. Assumes lightly-loaded, single-processor system; see Section 5.2.1, “Clock AC Specifications” for more information.

3. Rise and fall times for the SYSCLK input measured from 0.4 to 1.4 V.

4. Timing is guaranteed by design and characterization.

5. Guaranteed by design.

6. The SYSCLK driver’s closed loop jitter bandwidth should be less than 1.5 MHz at –3 dB.

7. Relock timing is guaranteed by design and characterization. PLL-relock time is the maximum amount of time required for PLL

lock after a stable VDD and SYSCLK are reached during the power-on reset sequence. This specification also applies when

the PLL has been disabled and subsequently re-enabled during sleep mode. Also note that HRESET must be held asserted

for a minimum of 255 bus clocks after the PLL-relock time during the power-on reset sequence.

Figure 3 provides the SYSCLK input timing diagram.

SYSCLK

VM

VM

VM CVIL

CVIH

tKHKL

tKR

tKF

tSYSCLK

VM = Midpoint Voltage (OVDD/2)

Figure 3. SYSCLK Input Timing Diagram

5.2.2 Processor Bus AC Specifications

Table 9 provides the processor bus AC timing specifications for the MPC7457 as defined in Figure 4 and

Figure 5. Timing specifications for the L3 bus are provided in Section 5.2.3, “L3 Clock AC

Specifications.”

MPC7457 RISC Microprocessor Hardware Specifications, Rev. 8

18

Freescale Semiconductor

Share Link: