MAXQ3180(2008) Ver la hoja de datos (PDF) - Maxim Integrated

Número de pieza

componentes Descripción

Fabricante

MAXQ3180
(Rev.:2008)

Low-Power, Multifunction, Polyphase AFE

Maxim Integrated 

Rev 0; 2/08

Low-Power, Multifunction, Polyphase AFE

General Description

The MAXQ3180 is a dedicated electricity measurement

front-end that collects and calculates polyphase volt-

age, current, power, energy, and many other metering

and power-quality parameters of a polyphase load. The

computed results can be retrieved by an external mas-

ter through the on-chip serial peripheral interface

(SPI™) bus. This bus is also used by the external mas-

ter to configure the operation of the MAXQ3180 and

monitor the status of operations.

The MAXQ3180 performs voltage and current measure-

ments using an integrated ADC that can measure up to

seven external differential signal pairs. An eighth differ-

ential signal pair is used to measure the die tempera-

ture. An internal amplifier automatically adjusts the

current channel gain to compensate for low-current

channel-signal levels.

Applications

3-Phase Multifunction Electricity Meters

Remote Terminal Unit (RTU) Applications for

Electric Load Management

Features

♦ Supports IEC 60687, IEC 61036, and IEC 61268

Standards

♦ Compatible with 3-Phase/3-Wire, 3-Phase/4-Wire,

and Other 3-Phase Services

♦ Calculates Active/Reactive/Apparent Energy, RMS

Voltage, RMS Current, Voltage Phasor Angle, and

Line Frequency

♦ Less Than 0.1% Active Energy Error Over a

Dynamic Range of 1000:1 at +25°C

♦ Less Than 0.2% Reactive Energy Error Over a

Dynamic Range of 1000:1 at +25°C

♦ Better Than 0.5% Accuracy for RMS Voltage and

RMS Current

♦ Two Pulse Outputs: One for Active Power and

One Selectable Between Reactive and Apparent

Power

♦ Programmable Pulse Width

♦ Programmable Startup Current Threshold

♦ Programmable Meter Constant

♦ Up to 21st Harmonic Measurement

♦ Neutral Line Current Measurement

♦ Calculates Amp-Hours in the Absence of Voltage

Signals

♦ On-Chip User-Programmable Thresholds for Line

Voltage Undervoltage and Overvoltage Detection

♦ On-Chip Digital Integrator Enables Direct

Interface-to-Current Sensors with di/dt Output

♦ On-Chip Digital Temperature Sensor

♦ Precision Internal Voltage Reference 2.048V

(30ppm/°C Typical); Also Supports an External

Voltage Reference Input

♦ Active Energy of Each Phase and Combined

3-Phase (kWh), Positive and Negative

♦ Active Power of Each Phase and Combined

3-Phase (kW)

♦ Reactive Energy of Each Phase and Combined

3-Phase (kVarh), Quadrants 1 to 4

♦ Reactive Power of Each Phase and Combined

3-Phase (kVar)

♦ Apparent Energy of Each Phase and Combined

3-Phase (kVAh)

♦ Apparent Power of Each Phase and Combined

3-Phase (kVA)

♦ Line Frequency (Hz)

♦ Power Factor

♦ Overcurrent and Overvoltage Detection

♦ Voltage Sag Detection

♦ RMS Current and RMS Voltage

♦ Line-Cycle-Wise Instant Current, Voltage, and

Power

♦ Phase Sequence Error Detection

♦ Phase Voltage Absence Detection

♦ Supports Software Meter Calibration

♦ Up to 3-Point Multipoint Calibration to

Compensate for Transducer Nonlinearity

♦ Power-Fail Detection

♦ Bidirectional Reset Input/Output

♦ SPI-Compatible Serial Interface with Interrupt

Request (IRQ) Output

♦ Single 3.3V Supply, Low Power (10mW Typical)

♦ 28-Pin TSSOP Package

Ordering Information

PART

TEMP RANGE

PIN-

PACKAGE

MAXQ3180-RAN+

-40°C to +85°C

28 TSSOP

+Denotes a Pb-free/RoHS-compliant package.

MAXQ is a registered trademark of Maxim Integrated Products, Inc.

SPI is a trademark of Motorola, Inc.

Pin Configuration and Typical Application Circuit appear at

end of data sheet.

Note: Some revisions of this device may incorporate deviations from published specifications known as errata. Multiple revisions of any device may be

simultaneously available through various sales channels. For information about device errata, go to: www.maxim-ic.com/errata.

________________________________________________________________ Maxim Integrated Products 1

For pricing, delivery, and ordering information, please contact Maxim Direct at 1-888-629-4642,

or visit Maxim’s website at www.maxim-ic.com.

Share Link: