Power-up and delivery state
M95160 M95160-W M95160-R M95160-DF
7
Power-up and delivery state
7.1
Power-up state
After power-up, the device is in the following state:
• Standby power mode,
• deselected (after power-up, a falling edge is required on Chip Select (S) before any
instructions can be started),
• not in the Hold condition,
• the Write Enable Latch (WEL) is reset to 0,
• Write In Progress (WIP) is reset to 0.
The SRWD, BP1 and BP0 bits of the Status Register are unchanged from the previous
power-down (they are non-volatile bits).
7.2
Initial delivery state
The device is delivered with:
• the memory array set to all 1s (each byte = FFh)
• Status register: bit SRWD =0, BP1 =0 and BP0 =0
• Identification page: byte values are Don’t Care.
30/47
DocID022580 Rev 5