LTC600-S Ver la hoja de datos (PDF) - LEM Industrial
Número de pieza
componentes Descripción
Fabricante
LTC600-S Datasheet PDF : 4 Pages
| |||
Current Transducer LTC 600-S
Isolation characteristics
Vd
R.m.s. voltage for AC isolation test, 50 Hz, 1 mn
13.4 2)
kV
1.5 3)
kV
V
R.m.s. voltage for partial discharge extinction
> 2.8
kV
e
Min
dCp Creepage distance
66.70
mm
dCl Clearance distance
45.90
mm
CTI Comparative Tracking Index (Group I)
600
Notes : 2) Between primary and secondary + shield
3) Between secondary and shield.
Safety
This transducer must be used in electric/electronic equipment with respect to
applicable standards and safety requirements in accordance with the following
manufacturer's operating instructions.
Caution, risk of electrical shock
When operating the transducer, certain parts of the module can carry hazardous
voltage (eg. primary busbar, power supply).
Ignoring this warning can lead to injury and/or cause serious damage.
This transducer is a built-in device, whose conducting parts must be inaccessible
after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
LEM
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.
060613/3
Page 2/4
www.lem.com
Share Link: 