LS037V7DW01 Ver la hoja de datos (PDF) - Sharp Electronics
Número de pieza
componentes Descripción
Fabricante
LS037V7DW01 Datasheet PDF : 26 Pages
| |||
LCP-06008A-17
(14)Handling Precautions
14-1) Insertion and taking out of FPCs
(1) Be sure insert and take out of the FPC into the connector of the set after turning off the power supply
on the set side.
14-2) Handling of FPCs
(1) The FPC for LCD panel shall be bent only slit portion. The bending slit shall be bent uniformly
on the whole slit portion with bending radius larger than 1.0mm ,and only inner side (back side of the
module). Don’t bend it outer side (display surface side).
(2) Don’t give the FPCs too large force, for example, hanging the module with holding FPC. Moreover,
Do not put stress on the components mounted on FPC to avoid failure of the components.
14-3) Installation of the module
(1) On mounting the module, be sure to fix the module on the same plane. Taking care not to warp or twist
the module.
14-4)Precaution when mounting
(1) If water droplets and oil attaches to it for a long time, discoloration and staining occurs. Wipe them off
immediately.
(2) Glass is used for the TFT-LCD panel or touch panel. If it is dropped or bumped against a hard object, it
may be broken. Handle it with sufficient care.
(3) As the CMOS IC is used in this module, pay attention to static electricity when handling it. Take a
measure for grounding on the human body.
14-5)Others
(1) The liquid-crystal is deteriorated by ultraviolet rays. Do not leave it in direct sunlight and
strong ultraviolet rays for many hours.
(2) If it is kept at a temperature below the rated storage temperature, it becomes coagulated and
the panel may be broken. Also, if it is kept at a temperature above the rated storage temperature,
it becomes isotropic liquid and does not return to its original state. Therefore, it is desirable to keep it
at room temperature as much as possible.
(3) If the LCD breaks, don’t put internal liquid crystal into the mouth. When the liquid crystal sticks to the
hands, feet and clothes, wash it out immediately.
(4) Wipe off water drop or finger grease immediately. Long contact with water may cause discoloration or
spots.
(5) Observe general precautions for all electronic components.
(6) Static image should not be displayed more than 5 minutes in order to prevent from occurrence of
residual image.
Share Link: 