IRU1175 Ver la hoja de datos (PDF) - International Rectifier
Número de pieza
componentes Descripción
Fabricante
IRU1175 Datasheet PDF : 6 Pages
| |||
IRU1175
ELECTRICAL SPECIFICATIONS
PARAMETER
Control Pin Current
Adjust Pin Current
SYM TEST CONDITION
MIN TYP MAX UNITS
Vadj=0V for all below conditions.
Vctrl=2.75V, Vin=2.05V, Io=1.5A
15
mA
Vctrl=2.75V, Vin=2.05V, Io=3A
30
Vctrl=2.75V, Vin=2.05V, Io=5A
50
Vctrl=2.75V, Vin=2.05V, Io=7.5A
75
Iadj Vctrl=2.75V, Vin=2.05V, Vadj=0V
50 120 µA
Note 1: Low duty cycle pulse testing with Kelvin con-
nections are required in order to maintain accurate data.
Note 2: Dropout voltage is defined as the minimum dif-
ferential between Vin and Vout required to maintain regu-
lation at Vout. It is measured when the output voltage
drops 1% below its nominal value.
Note 3: Minimum load current is defined as the mini-
mum current required at the output in order for the out-
put voltage to maintain regulation. Typically the resistor
dividers are selected such that it automatically main-
tains this current.
PIN DESCRIPTIONS
PIN # PIN SYMBOL PIN DESCRIPTION
1
Vsense
This pin is the positive side of the reference which allows remote load sensing
to achieve excellent load regulation.
2
Adj
A resistor divider from this pin to the Vout pin and ground sets the output voltage.
3
Vout
The output of the regulator. A minimum of 10µF capacitor must be connected from this
pin to ground to insure stability.
4
Vctrl
This pin is the supply pin for the internal control circuitry as well as the base drive for
the pass transistor. This pin must always be higher than the Vout pin in order for
the device to regulate. (see specifications)
5
Vin
The input pin of the regulator. Typically a large storage capacitor is connected from this
pin to ground to insure that the input voltage does not sag below the minimum drop
out voltage during the load transient response. This pin must always be higher than
Vout in order for the device to regulate. (see specifications)
Rev. 1.2
11/29/99
2-81
Share Link: 