Figure 10. Footprint recommendations (dimensions in
mm)
0.40
0.50
0.20
0.58
1.40
HSP061-4M10
μQFN-10L dimension values
Figure 11. Marking
H4 M
2.20
Note:
Product marking may be rotated by 180° for
assembly plant differentiation. In no case
should this product marking be used to orient
the component for its placement on a PCB.
Only pin 1 mark is to be used for this purpose.
Figure 12. μQFN-10L tape and reel specification
Dot identifying Pin A1 location
2.0
0.25
Ø 1.55
4.0
0.55
All dimensions are typical values in mm
1.35
4.0
User direction of unreeling
DS9279 - Rev 4
page 5/10